• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

yellow

  1. IMG_20211218_112100.jpg

    IMG_20211218_112100.jpg

    Pull example yellow
  2. J

    Cybs' Hybrid 1st pull yellow, 2nd pull brown

    1- Before to start the tek I did an extra step to increase yield. I first mixed the water with bark powder, heat it to let the water penetrate the wood cells, then froze it once. 2- Acid Phase I add vinegar as the receipe suggested, and I also added citric acid (Ph is much lower) after 1h of...
  3. L

    I'd like the remove the "yellow" 🤔

    Hello there, Is somebody aware of a method the isolate/separate the "yellow" substance from a dmt+ether solution ? I tried different techniques but the yellow always ends up into the ether solution when I am about to put it in the freezer. So essentially I am back to the good old "redissolve...
  4. Re-x-ed with acetone

    Re-x-ed with acetone

    The most neon yellow DMT I ever extracted. Probably lots of Oligomer going on since I heated the solution to 65C on my hotplate stirring bar. With the knowledge from the thread from Loveall I will not do that again. 26C max heating with silvent solvent on top (that has a boiling point of only 32C.
Back
Top Bottom