Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Reply to thread

Message

Shares the yopo pen with more friends. Notes:

- Some people feel nausea the first time they go into the bufotenine space. It only lasts for about 10 to 15 seconds.
- Subsequent trips are free of nausea.

Regarding washes. I dissolved a sample of the bufo oil (1.2g) in a small ammount of acetone. Then, I added naptha to try to xtalize it. It did not xtalize (oil again).

Out of curiosity, I evaped the naphtha. 100mg of a mysterious tan powder appeared. This can be considered a "naphtha wash". The powder vaporized well in e-mesh but zi didn't feel anything from it. Seems like inactive stuff in the oil ~8%.

Not sure if doing this wash is needed for the ejuice process, but here would be the refined version:

- 100g of seeds ground
- Mixed in 25g of sodium carbonate and 50g of water (note: 10g of sodium carbonate should also work, or simply use 60g of saturated sodium carbonate solution).
- Dried paste in oven at 170F
- Pulled with acetone 3x (~175ml each time) trough filter
- Drierd over CaCl2 overnight which also allowed sediment to settle to a clear solution
- Carefully decanted and salted with 10g of benzoic acid
- Decant benzate xtals that form after a few days
- Wash with boiling acetone (optional?
- Dry
- Dissolve in small ampmount of water
- Add enough sodium carbonate to make a pH of 9.6 (use buffer calculator)
- Pull with dry boiking EA until no water remains
- Evap EA
- Dissolve oil in small amlunt of acetone and separate it from any insoluble parte
- Optional wash: Add 10x naphtha volume and allow oil to crash in fridge. Decant naphtha.
- Allow to fully evaporate
- ejiuce can be made easily over hot water bath, with 25% VG, 75% PG. Optionally 0.2 parts citric acid can be added to lower pH and perhaps for longer storage life (?).

Cheers

-

<blockquote data-quote="Loveall" data-source="post: 3865782" data-attributes="member: 20">Shares the yopo pen with more friends. Notes:- Some people feel nausea the first time they go into the bufotenine space. It only lasts for about 10 to 15 seconds.- Subsequent trips are free of nausea.Regarding washes. I dissolved a sample of the bufo oil (1.2g) in a small ammount of acetone.&nbsp; Then, I added naptha to try to xtalize it. It did not xtalize (oil again).Out of curiosity, I evaped the naphtha. 100mg of a mysterious tan powder appeared. This can be considered a &quot;naphtha wash&quot;. The powder vaporized well in e-mesh but zi didn&#039;t feel anything from it. Seems like inactive stuff in the oil ~8%.Not sure if doing this wash is needed for the ejuice process, but here would be the refined version: - 100g of seeds ground- Mixed in 25g of sodium carbonate and 50g of water (note: 10g of sodium carbonate should also work, or simply use 60g of saturated sodium carbonate solution).- Dried paste in oven at 170F- Pulled with acetone 3x (~175ml each time) trough filter- Drierd over CaCl2 overnight which also allowed sediment to settle to a clear solution- Carefully decanted and salted with 10g of benzoic acid- Decant benzate xtals that form after a few days- Wash with boiling acetone (optional?- Dry- Dissolve in small ampmount of water - Add enough sodium carbonate to make a pH of 9.6 (use buffer calculator)- Pull with dry boiking EA until no water remains- Evap EA- Dissolve oil in small amlunt of acetone and separate it from any insoluble parte- Optional wash: Add 10x naphtha volume and allow oil to crash in fridge. Decant naphtha.- Allow to fully evaporate- ejiuce can be made easily over hot water bath, with 25% VG, 75% PG. Optionally 0.2 parts citric acid can be added to lower pH and perhaps for longer storage life (?).Cheers-</blockquote>

[QUOTE="Loveall, post: 3865782, member: 20"] Shares the yopo pen with more friends. Notes: - Some people feel nausea the first time they go into the bufotenine space. It only lasts for about 10 to 15 seconds. - Subsequent trips are free of nausea. Regarding washes. I dissolved a sample of the bufo oil (1.2g) in a small ammount of acetone. Then, I added naptha to try to xtalize it. It did not xtalize (oil again). Out of curiosity, I evaped the naphtha. 100mg of a mysterious tan powder appeared. This can be considered a "naphtha wash". The powder vaporized well in e-mesh but zi didn't feel anything from it. Seems like inactive stuff in the oil ~8%. Not sure if doing this wash is needed for the ejuice process, but here would be the refined version: - 100g of seeds ground - Mixed in 25g of sodium carbonate and 50g of water (note: 10g of sodium carbonate should also work, or simply use 60g of saturated sodium carbonate solution). - Dried paste in oven at 170F - Pulled with acetone 3x (~175ml each time) trough filter - Drierd over CaCl2 overnight which also allowed sediment to settle to a clear solution - Carefully decanted and salted with 10g of benzoic acid - Decant benzate xtals that form after a few days - Wash with boiling acetone (optional? - Dry - Dissolve in small ampmount of water - Add enough sodium carbonate to make a pH of 9.6 (use buffer calculator) - Pull with dry boiking EA until no water remains - Evap EA - Dissolve oil in small amlunt of acetone and separate it from any insoluble parte - Optional wash: Add 10x naphtha volume and allow oil to crash in fridge. Decant naphtha. - Allow to fully evaporate - ejiuce can be made easily over hot water bath, with 25% VG, 75% PG. Optionally 0.2 parts citric acid can be added to lower pH and perhaps for longer storage life (?). Cheers - [/QUOTE]