You should see two layers. The fact that you didn’t see layers form means something is wrong. I wonder what could cause this? Is your elemi oil clear like the DMSO?

Adding more DMSO will make the solvent mix less polar and it will dissolve more unwanted compounds. So it will affect it in a negative way. It all depends on how much you added. The fact that the sedative seemed to come through means to me that maybe too much DMSO was added, making the sedative soluble in the solvent mix. It’s all about polarity. If you add more water, the polarity goes up and the sedative is less soluble. Add too much water and then the elemicin is also less soluble. If you add more DMSO the polarity does down and the sedative is more soluble in the solvent mix.

The DMSO/Water mix needs to be exactly what’s in the tech, or it’s not going to give results exactly like what SWIM gets.

I think I need to post some pics. Next time SWIM does this tech he’s going to take pictures of all the steps so people can see exactly how it works.