SWIM has been working with acetates for a while now and he is now convinced that they can be used for every purpose that would be needed.
(1) creating a smokable jimjam product (tested)
(2) creating a smokable jungle+ N-N-DMT-oxide product (partially tested. separated but not evaporated/smoked)
(3) creating a smokable N-N-DMT product (partially tested, separated but not evaporated/smoked)
(4) creating an ingestable high-accuracy tincture for pharmahuasca, either (a)jimjam or (b)N-N-oxide+Jungle mix (tested)
(5) creating a sublingual tincture for lingahuasca, either (a)jimjam or (b)N-N-oxide+Jungle mix (tested)
(6) evaporating onto herbs for changa (purely theoretical)
Now whichever tek is used is not important, whether using a limtek, STB, A/B, whatever.
to create a situation with the freebase alkaloids from MHRB are contained within a solvent. Either d-limonene (tested), xylene (tested), or toluene (untested)
Once the solvent has been isolated from the bark then the mix is placed in a container that can be shaken without spillage.
Separatory funnel would be best.
A zip lock bag (that is solvent-safe) works perfectly fine.
A simple seal-able container, preferable glass or solvent-safe plastic could be used with a turkey baster and/or medicine dropper.
Added to the solvent is 20-25ml of 5% vinegar. The mix is shaken vigorously several times over 5 minutes.
(SWIM's calculations and practical tests suggest each ml can convert ~150mg of DMT (rounding down), so each pull can convert 3.000g to 3.750g of alkaloids.
SWIM's tests also suggest that at 95-99% of the alkaloids pulled by 5% vinegar are DMT related compounds.)
Once the bottom (now slightly-yellow) vinegar has been separated from the solvent via the separatory funnel, cutting the corner of the plastic bag or turkey baster the process can be repeated a second time with fresh vinegar in the solvent to make sure all the alkaloids are converted and dissolved into the vinegar.
The resulting vinegar can be dealt with in a few ways.
Although if it is left to evaporate at room temperature and a light-orange gel-like substance will be achieved.
This will contain .7575% freebase/ 132% the weight of freebase DMT and can be used for oral pharmahuasca or sublingual lingahuasca.
But this product is not very useful, it can be heated indirectly over a hot water bath (simmering pot) at >120F/49C to convert to freebase.
Though This method the slowest and least useful
3 others would be better and faster.
A:If the vinegar is placed on a flat-bottomed dish and evaporated slowly over a simmering or boiling pot of water (so the dish does not sit in, but above the water) then a pure freebase jimjam goo will be achieved
B:If the vinegar is placed in a food dehydrator and dehydrated then an identical pure freebase product could be achieved
C: (untested) If the vinegar is placed in an oven at 200F/95C then the same freebase product would be achieved, though the high heat could result in loss of product, SWIM will test the method.
Theoretically the vinegar could also be placed in a container with some herbs and evaporated indirectly over simmering/boiling water for enhanced-leaf for changa (6) though it would probably be easier just to melt the goo into the herb later.
Now assuming of of the lettered methods were used a completely smokable freebase jimjam product (1) is achieved. (tested)
(the acetates are evaporated off since the flash point of acetic acid is 39C. The process leaves the freebase behind)
These can either be used in a tincture by dissolving the product in a water/vinegar mix (1:4 vinegar to water has worked for SWIM) which can be used as an ingredient for oral pharmahuasca (4a) or sublingual lingahuasca (5a)
If this product is mixed with hot tap water then the jungle and N-N-DMT-oxide alkaloids will be dissolved and the freebased N-N-DMT will cloud up the water. (tested)
If the mix is put through a filter then the filtered water can be evaporated to achieve freebase jungle+N-N-DMT-oxide mix which can be smoked (2) or used as an ingredient for oral pharmahuasca (4b) or sublingual lingahuasca (5b) (untested)
The freebase DMT should be caught in the coffee filter and dried to achieve pure smokable N-N-DMT (3) (untested)
Conclusion: This method is useful because it can be adapted to be 100% food safe (lime + d-limonene tek) and even if lye or xylene are used then the final step makes sure that that no lye is left in the product and the evaporation evaporates the xylene, it there is any.
Apart from the safety aspect, this method is extremely simple using no materials other than vinegar and water, no strong bases need to be cleaned up/separated/purified. This method is relatively quick, the evaporation can be done in an hour or less and the salting in 5 minutes if you're fast. Previously the only other food-safe method of obtaining freebase jimjam/jungle required the impure and extremely slow evaporation of limonene. Now it is pure and quick.
Special thanks to Blueskine, his experiments with acetates were the first for removing acetates from DMT acetates
(this is clearly a first draft and once everything has been tested it will put in a tek with pictures and everything. This is just a jumble of words even some of the experienced DMT-ers might not fully understand.)
(1) creating a smokable jimjam product (tested)
(2) creating a smokable jungle+ N-N-DMT-oxide product (partially tested. separated but not evaporated/smoked)
(3) creating a smokable N-N-DMT product (partially tested, separated but not evaporated/smoked)
(4) creating an ingestable high-accuracy tincture for pharmahuasca, either (a)jimjam or (b)N-N-oxide+Jungle mix (tested)
(5) creating a sublingual tincture for lingahuasca, either (a)jimjam or (b)N-N-oxide+Jungle mix (tested)
(6) evaporating onto herbs for changa (purely theoretical)
Now whichever tek is used is not important, whether using a limtek, STB, A/B, whatever.
to create a situation with the freebase alkaloids from MHRB are contained within a solvent. Either d-limonene (tested), xylene (tested), or toluene (untested)
Once the solvent has been isolated from the bark then the mix is placed in a container that can be shaken without spillage.
Separatory funnel would be best.
A zip lock bag (that is solvent-safe) works perfectly fine.
A simple seal-able container, preferable glass or solvent-safe plastic could be used with a turkey baster and/or medicine dropper.
Added to the solvent is 20-25ml of 5% vinegar. The mix is shaken vigorously several times over 5 minutes.
(SWIM's calculations and practical tests suggest each ml can convert ~150mg of DMT (rounding down), so each pull can convert 3.000g to 3.750g of alkaloids.
SWIM's tests also suggest that at 95-99% of the alkaloids pulled by 5% vinegar are DMT related compounds.)
Once the bottom (now slightly-yellow) vinegar has been separated from the solvent via the separatory funnel, cutting the corner of the plastic bag or turkey baster the process can be repeated a second time with fresh vinegar in the solvent to make sure all the alkaloids are converted and dissolved into the vinegar.
The resulting vinegar can be dealt with in a few ways.
Although if it is left to evaporate at room temperature and a light-orange gel-like substance will be achieved.
This will contain .7575% freebase/ 132% the weight of freebase DMT and can be used for oral pharmahuasca or sublingual lingahuasca.
But this product is not very useful, it can be heated indirectly over a hot water bath (simmering pot) at >120F/49C to convert to freebase.
Though This method the slowest and least useful
3 others would be better and faster.
A:If the vinegar is placed on a flat-bottomed dish and evaporated slowly over a simmering or boiling pot of water (so the dish does not sit in, but above the water) then a pure freebase jimjam goo will be achieved
B:If the vinegar is placed in a food dehydrator and dehydrated then an identical pure freebase product could be achieved
C: (untested) If the vinegar is placed in an oven at 200F/95C then the same freebase product would be achieved, though the high heat could result in loss of product, SWIM will test the method.
Theoretically the vinegar could also be placed in a container with some herbs and evaporated indirectly over simmering/boiling water for enhanced-leaf for changa (6) though it would probably be easier just to melt the goo into the herb later.
Now assuming of of the lettered methods were used a completely smokable freebase jimjam product (1) is achieved. (tested)
(the acetates are evaporated off since the flash point of acetic acid is 39C. The process leaves the freebase behind)
These can either be used in a tincture by dissolving the product in a water/vinegar mix (1:4 vinegar to water has worked for SWIM) which can be used as an ingredient for oral pharmahuasca (4a) or sublingual lingahuasca (5a)
If this product is mixed with hot tap water then the jungle and N-N-DMT-oxide alkaloids will be dissolved and the freebased N-N-DMT will cloud up the water. (tested)
If the mix is put through a filter then the filtered water can be evaporated to achieve freebase jungle+N-N-DMT-oxide mix which can be smoked (2) or used as an ingredient for oral pharmahuasca (4b) or sublingual lingahuasca (5b) (untested)
The freebase DMT should be caught in the coffee filter and dried to achieve pure smokable N-N-DMT (3) (untested)
Conclusion: This method is useful because it can be adapted to be 100% food safe (lime + d-limonene tek) and even if lye or xylene are used then the final step makes sure that that no lye is left in the product and the evaporation evaporates the xylene, it there is any.
Apart from the safety aspect, this method is extremely simple using no materials other than vinegar and water, no strong bases need to be cleaned up/separated/purified. This method is relatively quick, the evaporation can be done in an hour or less and the salting in 5 minutes if you're fast. Previously the only other food-safe method of obtaining freebase jimjam/jungle required the impure and extremely slow evaporation of limonene. Now it is pure and quick.
Special thanks to Blueskine, his experiments with acetates were the first for removing acetates from DMT acetates
(this is clearly a first draft and once everything has been tested it will put in a tek with pictures and everything. This is just a jumble of words even some of the experienced DMT-ers might not fully understand.)
