To be even more precise, these are the details of how I performed my first extraction that was send to Kykeon Analytics:

1. Wrap the 1:1 mix of CBD : Zeolite very tightly in aluminium foil as described in the OP.
2. Heat the oven up to 105C in the "hot air modus".
3. When the oven reached 105C I put the package in the oven and directly set the oven to go to 150C ("hot air modus").
4. Wait 15 minutes.
5. Get the package out of the oven and let it cool down to room temperature (I did this to check the results).
6. Since the result was a very light gray color I thought I did not heat it long enough and put it back in the oven for another 15 minutes at 150C ("hot air modus").
7. Get the package out of the oven, let it cool down to room temperature, unwrap it and let it settle in 96% ethanol to separate the zeolite from the mix.

Some notes that might be interesting (or not):

• Hot air ovens usually heat up faster than normal ovens, I know mine has a "boost" function that quickly reaches the desired temperature (Miele H7240BM).
• When I looked at the result after the first 15 minutes I exposed the result to oxygen since I had to open the package to take a look at it (and wrapped it up very tight again before putting it back in the oven), this might have degraded the percentage of Delta-9-THC?
• I let the end result including the zeolite stay together for many hours in the ethanol, I'm not sure if there would be any significant chemical reaction between the zeolite and "product" at room temperature.
• To evaporate the ethanol from the mixture I used a hot plate in the range of 64C to 80C+ while having a small fan blow softly over it.

Kind regards,

The Traveler