DMT & E-cig in 2025

[Wittypilgrim]

Hello,
I want to make my own DMT e-liquid, and after reading all your messages, I'm still missing a small clarification:
I'm using a Geekvape M100 mod with a Z nano 2.
My e-liquid consists of 2ml of DMT Freebase and 2ml of e-liquid with a 70%/30% VG/PG ratio (no nicotine).
My question is, which resistance should I use: 0.2, 0.4, or 0.6 ohms?
Also, how many watts should I set the mod to?
Thank you very much for your reply.

 

[61pete]

Hello,
I want to make my own DMT e-liquid, and after reading all your messages, I'm still missing a small clarification:
I'm using a Geekvape M100 mod with a Z nano 2.
My e-liquid consists of 2ml of DMT Freebase and 2ml of e-liquid with a 70%/30% VG/PG ratio (no nicotine).
My question is, which resistance should I use: 0.2, 0.4, or 0.6 ohms?
Also, how many watts should I set the mod to?
Thank you very much for your reply.

Sometimes, but not always, on the coil is printed the value in ohms and watt range.
Id go for the 0.4ohm one as a middle of the road experience.

Before you even put your freebase mix in the tank, you'd need to get a ballpark of watts range and a 0nic vape juice will do that.
Dont use a bakery/dessert flavor as they normally use a bit more heat to wake up the flavors.
A menthol/ice is also going to give a false idea.
Best is plain fruits like blackcurrant or a mix of tropical fruits.

For me a coke flavor is fine at 33w in my Hadaly with a 0.56 coil, but needs 44w in a Dead Rabbit R with a 0.2 mesh coil.
Start low and work your way up till the flavor is good and no burnt taste.

 

[Wittypilgrim]

Thank you for your reply.

I'm quite used to the substance and I want to get closer to a breakthrough with my rig.

I'll follow your advice and use a Blackcurrant flavor.

If I understand correctly, if I want a stronger experience, I should use a 0.2 ohm coil.

The coil indicates 50W to 55W.

Could I get a stronger experience or a breakthrough if I set the mod to 55W?

 

[61pete]

Thank you for your reply.
I'm quite used to the substance and I want to get closer to a breakthrough with my equipment.
I'll follow your advice and use a Blackcurrant flavor.

If I understand correctly, if I want a stronger experience, I should use a 0.2 ohm coil.

The coil says 50W to 55W.

Will I be able to achieve a stronger experience or a breakthrough if I set the mod to 55W?

The wattage doesnt determine the "break through" dose.
The amount of vaporized DMT in your lungs does.
So maybe go for the 0.2ohm coil then and start at 45w so you dont burn the deems.

 

[1Starway7]

The wattage doesnt determine the "break through" dose.
The amount of vaporized DMT in your lungs does. on d
So maybe go for the 0.2ohm coil then and start at 45w so you dont burn the deems.

The wattage does have an effect on DMT VAPOR..ive found..
too low of a wattage can create a... weaker vapor with weaker effect.... but usually the higher watages settings ..[short of burning]....can send you flying ...with stronger effect...

 

[fractals4life]

The wattage doesnt determine the "break through" dose.

The wattage very much affects how much air you need to pull in to deliver a breakthrough dose of DMT though. Too low and there's not enough vapour in a lung full, too high and the wick can dry out and burn because juice is being boiled off faster than it can soak in.