Emesh with Nickel mesh

[Benwestblueboy]

Morning All,

First time poster so I hope I'm in the right area..

In the past I've only ever [had] DMT infused vape juice.. I've decided this time to invest in an emesh setup. I've purchased the geekvape aegis solo mod and an rta, however, I accidently purchased the vandyvape meshwire NI80 rather than the ss one.. Can I still use this mesh and if so what are the temperature settings.. Also this is the first time I've seen actual DMT powder and I was expecting it to be coarser but it's like talc.. Will the holes in the mesh be too big??

Don't want to screw this up, any help would be appreciated..


Cheers,

[Mod edit - not even a hint of sourcing, please!]

 

[downwardsfromzero]

Hello and welcome to the Nexus! Be sure to familiarise yourself with our Attitude Page inorder to make best use of the forum and its resources.


I personally wouldn't use nickel with a basic amine like DMT. You can test it out with a small amount if you like (but don't inhale the vapours) and if you see any green discolouration on the nickel that's a definite no-no. You're probably just better off getting hold of the right stainless steel mesh, however.

DMT melts easily at a temperature below that of boiling water so it will be easy to form it into an aggregated lump. If you want crystals you'd be better off recrystallising it from naphtha, especially since it appears you didn't extract the material yourself. Some would argue you've screwed that bit up already but at least there's no hurry in this - you can find out all you need to know with a bit of digging around in the forum, and there's also a chat function if you want the opportunity of a real-time(ish) interaction.