Yeah I saw your post previously. I'm just thinking going off previous (A/B) Teks with the same powder I'm thinking 62% sound about right comparing previous and current yields. However this observation is just that I could be completely wrong, comparing yields of different Teks is in no way accurate.

I was literally thinking about doing something along those lines.

I have a 4th run I may do tomorrow if I have time or I'll just sacrifice 400mg or 500mg of stuff I already have.

After my first attempt (that I stuffed up, sort of) getting excess moisture out via the microwave i think is a good way to go. I found a massive difference in yield between 1st and 3rd attempt on the same powder. Only difference between the two attempts was water content. So  drier seems to be better and as you pointed out is better for solvent reuse.

I'll go again in the next couple days regardless.

As for the conversion.

i'm thinking dissolve about 500mg in 50ml of water add caustic soda until I have a PH of say 12 and then pull with 20ml xylene  and salt it out with say 20ml water+HCL. Does that sound about right?

Regardless, Loveall I must say best mescaline TEK I've ever done, fastest, easiest, cleanest and probably purest tek out there. So hats off to everyone who contributed.

Don't know why you named it CIELO TEK should be the Ultimate Fucken Mescaline TEK.