• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Hybrid Tek idea

Migrated topic.
LibertyforAll

LibertyforAll

Claro in Vitam
If powdered acacia was taken and basified as in the hippie salad oil tek, ie miced to a dough like consistency, then naptha was used on the dough, would this result in a crude full spectrum pull?
I have seen tested 25g of this, and there was not any oils or fats visible about 10 minutes after the naptha addition, though the naptha had clouded. Thoughts?
 
Mixed * not miced.

First naptha pull showed a small amount of white crystals form on suspended dust particles after a few hours in deep freezer, that redissolved after the naptha began to warm. This naptha was unconcentrated and was straight off the 'dough'

Also worth noting is that now several hours after, there is still no oil or fat layer.

Updates will be posted
 
Yea, when I got my first batch of ACRB, I tried a STB extraction just to see if it would work and I yielded a fairly small amount of white crystals. The strange thing was that when an accurately weighed dose of the crystals was vaporized, it had very little effect. I would start to feel the beginning of a DMT experience, then it would fade, then it would come back, then it would fade, etc. several times. I tried a very large dose and finally did hit breakthrough, but only after onset feeling coming and going several times. Very strange...
 
What i did with my Acacia, was do a room temp water extraction on it and let it sit overnight, the next day filtered out the root bark, and let the water evaporate until there's only a little left (unfortunately i accidentally spilled a bit of the brew as my bowl got knocked over, but i still managed to save most of it). And once there was only a little bit of water left i then added in straight Sodium Carbonate, let it dry all the way and then pulled with room temp Acetone. The Acetone was left to dry, and then more Acetone was added to gather up all the Acacia goop and then evaporated that onto some Lemon Balm. The result, was 4 grams of extract from 200 grams of Acacia Confusa, and was evaporated onto 12 grams of Lemon Balm for a resulting 16 grams of pretty good Changa. I've done this with Mimosa inner root bark as well and each time i'd pull 5 grams of DMT from 100 grams.
 
^^ Yes.

Works very good with acetone.

I did it with mhrb tea resin from about 200g of bark powder from 3x acid cooks, evaporated down to a resin.

Mixed with caoh (calcium hydroxide, lime), and some water to make a paste. Let it fully dry over night, powdered, and pulled with acetone.

You can just fasa it from there, to get fumarates, base it again and pull with heptane to get white xtyals, or evap the acetone to get a full spectrum freebase oil. Dissolve that in near boiling hot heptane, and freeze-x in a shot glass.

IIRC, the first 50ml heptane pull from my oil, from 200g of bark, precipitated out ~750mg of white freebase crystals. CAme out to a total of ~ 2.5ish grams of white freebase, and ~ another gram of active tryptamine oil, probably n-oxide and some other stuff.

IT works very, very good.

Even if you just basify a resin from an evaporated tea, with caoh, or sodium carbonate and pull with hot heptane, then freeze-x.

For fumarates for pharma, just use dry acetone on a dried basified resin powder to pull, and fasa it.

Even worked good for some 4-aco-dmt hcl goo i had that got a bit too hydrated. Same tek, just ended up with a fumarate salt, thats a lot more stable, and much, much less hydroscobic.

Good yields, simple, easy, quick, and very efficient as far as how much solvents you are using.
 
Back
Top Bottom