• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Reply to thread

just posting a update


the last attempt was a partial failure (i know i can do better


anyhow the results


test 1 pre shredded 457mg from 25g of bark +/- 3mg


test 2 whole bark   472mg from 25g of bark +/- 3mg


so from 50g of bark thats about 930 mg of bark, comparable to standard sodium chloride results, but no trace or is coloured alkaloids showed up, which is interesting because that means with the trace artifacts this number should go much higher. what came out was absolutely crystal clear (if anyone has seen pictures of those "diamonds" thats what appeared)




i am reattempting this test again, same parameters


250mg deionized watch

50mg 5% acetic acid

25 g from two sources

acid boil for one hour each

70g magnesium sulphate (ONCE FULLY COOLED)

conversion to base (2 table spoons of lye, dissolved in the minimal ammount of water)

extract with naphtha



my mistake the first time where that i added the magnesium sulphate while the soup was still esentially at boiling temp (probably ripped apart the alkaloids, had a similar experience when i tried to add zinc to a different boil) and too much water was used (added too much trying to compensate for the boil off and did not check the total, this means that the saturation level could not be reached)


so here is to round two.


Back
Top Bottom