swim just tried this tek with a tiny amount of cactus - the tek was hurried and is not finished yet - only 2 pulls were done and the cactus hasnt even digested properly yet - all pulls were done within 5 hours of mixing the cactus and lime

28g outer green flesh from a mix of long spined peruvian torch, bridgesii and bridgesii monstrose were used

mixed with lime and water

it looked better later on

Then evaporated from the vinegar pulls swim yeilded

about 150mg so far - the rest of the work will be done on it today

this stuff is very sticky and kinda hard to handle - is it really worth it to keep it in this form or should swim convert to hcl then wash with acetone - then evap the acetone for the non-mesc actives - anyone tried smoking them yet ?

also to convert this does swim disolve it in 75ml of water with 3 drops hcl added (same ratio as when salting from xylene) and evap ?

can that same ratio be used to salt out mesc hcl instead of using vinegar for the acetate ?

if salting out with hcl instead of vinegar does the hcl solution pick up as much as the acetate pull ?