Nanaki
Rising Star
Since this has experience, SWIM thought it best to post here instead of the FASA Tek.
SWIM did a STB, using Xylene to pull some nice yellow liquid.
He had 150ml Acetone mixed with 100mg Fumaric Acid, FASA.
He poured about 1/2 of the FASA into a collection of his first few pulls, and shook the white concoction and let it sit.
When he poured this through a filter, there was white residue stuck to the bottom of the glass he was unable to scrape off. Even putting in more acetone, it didn't dissolve.
What dried on the filter were white clumps, he suspects to have an excessive amount of fumaric acid. He left it to dry, and put it in the oven at the lowest setting it would go, 170 degrees. But left it only for 8 mins at at time, then turned the oven off.
He tried to use this white powder to make some aya analogue. He used 50mg of THH and around 70mg of Harmine, and 60mg of this white powder.
He did feel some effects, and saw slight geometry in the wall, and distortion of space. It also hit quicker (30 mins as opposed to an hour) than the time before.
He did use acetone, but may not have washed it the right way. This seemed like a weak experience, but he was also using much less harmine and THH than usual.
SWIM wonders a couple of things:
1) Does drying in the oven remove all Xylene?
2) Is any left over fumaric acid in the DMT Fumarate a bad thing?
3) Is there any way to keep the FASA from practically fusing itself to the bottom of the glass of Xylene pull?
SWIM did a STB, using Xylene to pull some nice yellow liquid.
He had 150ml Acetone mixed with 100mg Fumaric Acid, FASA.
He poured about 1/2 of the FASA into a collection of his first few pulls, and shook the white concoction and let it sit.
When he poured this through a filter, there was white residue stuck to the bottom of the glass he was unable to scrape off. Even putting in more acetone, it didn't dissolve.
What dried on the filter were white clumps, he suspects to have an excessive amount of fumaric acid. He left it to dry, and put it in the oven at the lowest setting it would go, 170 degrees. But left it only for 8 mins at at time, then turned the oven off.
He tried to use this white powder to make some aya analogue. He used 50mg of THH and around 70mg of Harmine, and 60mg of this white powder.
He did feel some effects, and saw slight geometry in the wall, and distortion of space. It also hit quicker (30 mins as opposed to an hour) than the time before.
He did use acetone, but may not have washed it the right way. This seemed like a weak experience, but he was also using much less harmine and THH than usual.
SWIM wonders a couple of things:
1) Does drying in the oven remove all Xylene?
2) Is any left over fumaric acid in the DMT Fumarate a bad thing?
3) Is there any way to keep the FASA from practically fusing itself to the bottom of the glass of Xylene pull?