I am using the stirrer on most of the extract. I tried to do 150g as opposed to 100g it was to thick so I poured a third(ish) out into a separate vessel and did two extractions.

I did f**k up good and proper though I should have only changed the one parameter. I am not claiming limonene is not as good. It does clearly have different properties from naphtha (it smells lovely for a start). I am sure that both solvents have there place depending on what factors are most important to your extraction.

The next time I extract I will do what I should have done this time and repeat my naphtha extraction 100 percent but with limonene and no extra bark (idiot).

To top it off all off I spilt a load of freebase mixed with water down the back of my soundsystem so will never know the full yield from this extraction.

Much respect to everyone at the nexus.