• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

solvent free tek for small amounts

Migrated topic.
hummus

hummus

Rising Star
So this hasn't been bioassayed yet, but it seemed to work very well in blending, before further grinding the product seemed almost identical to solvent-made changa.
Ingredients:
caapi leaf or your favourite blend
dmt
Materials:
small glass plate
razor blade
lighter
herb grinder
First, grind up your herbs very finely, with the caapi leaf it was dry and fragile so the leaves were run through a normal grinder, with continued grinding and holding the edges slightly open very finely powdered leaf was procured. Discard the stems etc.
Place your quantity of dmt onto the glass plate and spread about evenly so there is a thin layer of crystals onto the glass. Heat evenly from a distance of an inch or two with a lighter underneath the glass plate, carefully melting the dmt without vaporising it, doesn't take much heat.
The DMT should quickly melt first into a tacky gum and then upon further heating into an oily liquid. Now quickly, roll and spread the liquid around so that it forms an even film across the plate of glass and start sprinkling your finely powdered herbs into the liquid and sprinkle all over giving a slight excess of herbs. Quickly, stir and scrub the liquid into all of the herbs, sprinkling small amounts more as you go until you've got a satisfactory consistency. Keep scrubbing around as it re-solidifies and you'll find that there is very little spare dmt left over.
To ensure it's all at an even consistency, chuck it into a mortar and pestle and give it a quick grind, it should immediately turn into a nice fine even powder.
enjoy!
Theoretically, I wonder if pure harmalas could be dissolved into the liquid dmt?
 
Hi,

zubidlo smokes DMT this way only. He packs GVG with caapi leaves, spreads desired spice dose onto them and holds opened pipe under table lamp bulb till spice melt. Waits a minute and mixes leaves inside the pipe. Done.


Regards.
 
I wonder if you get the same kind of infusion with heat as you do with IPA or Acetone? hmm...maybe if you ensured it was heated up to a certain liquid state?
 
Hello,

stevowitz said:
I wonder if you get the same kind of infusion with heat as you do with IPA or Acetone? hmm...maybe if you ensured it was heated up to a certain liquid state?
Click to expand...

Well, of course.
I made some enhanced leaves by solvent before - liquid butane from can, 1:1 caapi leaves : DMT free base ratio and there was not much difference observed in potency and experience. Actually, when you make your mix in pipe you can do whatever ratio you prefer - like pack it with 120 mg of dried leaves and infuse let say 30mg of free base on it and you have 4:1 ratio with breakthrough dose of DMT and more RIMA alk. In my experience MUCH longer, more narrative, subtle, dark and creepy experience than straight DMT guaranteed. Afterglow very different and more tripy too. More RIMA with breakthrough DMT dose is better. Like 150-200 mg of caapi alk. (5-10g caapi brew), wait for half an hour and than hit your changa....Whau...whauu...whauuuuuu:d

Again, in my humble opinion there is no solvent tek needed to vape RIMA and DMT together. Of course DMT got melted into liquid state and than dried onto leaves. I smoked it like this many times and it worked every time. Love to smoke this for hours with my friends. I noticed that first trip is not the best one. Smoking changa is very manageable. You can trip like motherfuck for hours, but end it anytime you like.
I love and respect these plants. Things I experienced thanks to them I never forget:wink:



PS: Sorry if I sounded like smartass, I didn't mean to 'give advices' I just love to write and speak about changa.


Regards.
 
Back
Top Bottom