Toshido
Research & Development
I found this 2 yr old thread here, and instead of bumping it will just reference it here.
1) I just want to make sure this flask is fine. I would not use the included rubber stopper though.
Hailstorm in the above thread says that using a magnetic stirrer (which I have) and NO STOPPER is the best way to go. So from that, I can surmise that you would not want a cap on at anytime during the extraction process as you would be stirring and not shaking the contents of the jar.
2) OR, I could opt for this brewery stopper that has a large hole in it, allowing the solution to vent minimally.
These are the final questions I have before introducing the rough draft of my TEK and starting my first extraction, which I am not rushing in anyway. Thank you.
1) I just want to make sure this flask is fine. I would not use the included rubber stopper though.
Hailstorm in the above thread says that using a magnetic stirrer (which I have) and NO STOPPER is the best way to go. So from that, I can surmise that you would not want a cap on at anytime during the extraction process as you would be stirring and not shaking the contents of the jar.
2) OR, I could opt for this brewery stopper that has a large hole in it, allowing the solution to vent minimally.
These are the final questions I have before introducing the rough draft of my TEK and starting my first extraction, which I am not rushing in anyway. Thank you.