• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

What is your personal ratio? RB:NaOH:H2O

Migrated topic.
C

crakkbakk

Rising Star
I have always hated the 1gRB:1gNaOH:15mlH2O ratio. Even though I have never tried it. It just seems like a huge waste of water and space.

Swim is actually trying a 30g:30g:450mL right now as we speak. Takes up a quart sized jar? Kind of lame.

I usually don't count my ratio at all but I probaly should.


What is your personal ratio? Or what is your personal feel? Usually I just add enough water until it is liquidy and not sludgy (which is a big line of perception).
 
I have found using 1g MHRB: 1g NaOH: 10ml H2O the best ratio personally... and about 100ml of naphtha to allow enough of a layer to not pull up any base water sludge. I have also used 15ml of water per gram of bark and found it isn't necessary (too much). I also, found 6ml of water (found in a few teks out there) to be too little. Just my personal opinion.
 
DoingKermit said:
I have found using 1g MHRB: 1g NaOH: 10ml H2O the best ratio personally... and about 100ml of naphtha to allow enough of a layer to not pull up any base water sludge. I have also used 15ml of water per gram of bark and found it isn't necessary (too much). I also, found 6ml of water (found in a few teks out there) to be too little. Just my personal opinion.
Click to expand...
I had some great difficulties with that base water sludge and my thin 50ml layer of heptane, until I found the solution. I now pull up the layer in one of those plastic syringes, if water mixes in I simply squirt it out. I then empty the syringe in a temporary container, because some sludge will follow. By carefully decanting into the precipitationchamber I get rid of all the water.

I don't really get why there should be a lot of water, but I haven't experimented yet either. Do anyone know exactly where this 15ml figure has it's origin? The amount of NaOH is controlled by the amount of water (for correct pH) and the naphtha by the MHRB, so what controls the water?
 
well you dont want it too thick...you want the solvent to be able to mix very well with it..goopy=low yield
 
1:1:10-15
50-75g bark and lye, always use 750mL of water, granted SWIM does not do large batches as there is no need.
 
Back
Top Bottom