Xylene STB on unreliable source

[tropane]

So this plant has yielded swim about 1g per 500g mimosa... not good.
That's multiple pulls.

With xylene STB, he's produced about 120 single hits.
These are SWIM's special hits...
They usually take about 30mg DMT.

So 30mgx120...3.6 g ... this was from 700g mimosa.
Single Pull.
Take that as you will.
Much better than SWIM's naptha pulls.

Also, SWIM likes to note that although he thought his product was quite pure,
a friend commented on how it smelled like glue...
Maybe something to take into consideration on your next run.

 

[West-en]

You're using bad naphtha. Good naphtha should not differ to xylene that much.
Also, one should note that xylene does not only pull DMT. It also pulls a lot of unwanted alkaloids (if you're not making jungle spice) that will appear as impurities in your spice.

 

[acolon_5]

You're using bad naphtha. Good naphtha should not differ to xylene that much.
Also, one should note that xylene does not only pull DMT. It also pulls a lot of unwanted alkaloids (if you're not making jungle spice) that will appear as impurities in your spice.

You said it. Xylene is not as selective as Naphtha...that's one of the reasons that most teks call for naphtha...because it pulls mainly spice. Xylene pulls out a lot of other stuff from the bark than just DMT. So your yields will be much higher than with naphtha. This has been discussed at legnth before...you can check out the jungle spice threads for more info on using Xylene as a solvent for extractions.