What it is
A complete e-mesh kit for dry materials. Every kit uses the same regulated mod, the same 26 mm mesh deck, the same laser-cut screens and the same borosilicate glass.
Most e-mesh setups are a mix of different mods, decks, screen cuts and glass. A setting that works on one rig often does nothing on another. Because every part in this kit is the same, settings carry over from one person to the next.
Disclosure: this is a commercial product, and I am the person who made it. Staff OK'd this listing.
What is in the kit
Settings that have worked for me
If you run one, please post your wattage, airflow and screen size in the thread. That is the whole point of a standard kit.
Known limitations
Shipping
US kits ship with a battery. International kits ship without one because of airmail rules, so you supply your own 18650.
Links
Discussion thread: A Purpose-Built E-Mesh Device: Clear Glass Chamber, Dual Airflow, Laser-Cut Screens
Where to get it: Lucidus · The standardized e-mesh kit
A complete e-mesh kit for dry materials. Every kit uses the same regulated mod, the same 26 mm mesh deck, the same laser-cut screens and the same borosilicate glass.
Most e-mesh setups are a mix of different mods, decks, screen cuts and glass. A setting that works on one rig often does nothing on another. Because every part in this kit is the same, settings carry over from one person to the next.
Disclosure: this is a commercial product, and I am the person who made it. Staff OK'd this listing.
What is in the kit
- Regulated mod, single 18650, USB-C, about 81 x 35 x 27 mm
- 26 mm stainless mesh deck that clamps a flat screen
- Laser-cut SS316L 200 mesh screens in two sizes (11 x 13.9 mm and 13.9 x 13.9 mm)
- Three borosilicate glass tops: a cylinder, a bulb, and a bulb with a stainless percolator
- Adjustable airflow on the bottom and the top
- A loading tool that sits over the screen
Settings that have worked for me
- Use power mode. Temperature control gave readings that did not repeat from session to session.
- Screens read about 0.08 to 0.12 ohm. The reading shifts a little after burn-in, which is normal.
- I have run it from about 15 to 24 W. Start low and work up.
- Bottom airflow, two holes open on each side, has worked best for me. It gives a shorter, denser draw.
- The top vent is optional. It gives a smoother draw if bottom airflow feels harsh.
- More air cools the screen, so it needs more power. Change one thing at a time.
If you run one, please post your wattage, airflow and screen size in the thread. That is the whole point of a standard kit.
Known limitations
- Resistance this low sits near the bottom of what the chip reads. During development that caused occasional short warnings. A burn-in and a reset fixed it.
- A few mods showed a flickering main screen. Every unit is checked, and none with that fault are sold.
- Screens do not always heat perfectly evenly. In my experience that is true of every e-mesh setup. Even clamp pressure helps.
Shipping
US kits ship with a battery. International kits ship without one because of airmail rules, so you supply your own 18650.
Links
Discussion thread: A Purpose-Built E-Mesh Device: Clear Glass Chamber, Dual Airflow, Laser-Cut Screens
Where to get it: Lucidus · The standardized e-mesh kit