? bout dose & extraction

[stronjes]

On the first image you'll see in front of the razor a line of DMT. Would one consider this one or two hits? Doses? I use a nectar collector RN I imagine I'm looking at ~20mg could someone please LMK if that looks right that knows weight.
Also using no man's Tek mhrb 100 g I have done pretty much by the book, although I got busy and couldn't get to it for quite a while after the 2nd pull.
It's now been 4days and there's a weird yellow looking goo in between the mhrb sludge and the Naphtha layer? Is it still good to pull from

 

[redbird]

I strongly recommend you get a mg scale. They are highly affordable these days. That could be 2 hits, that could be 5. It's not likely to be that much but literally no one knows how much it weighs by looking at it.
If you insist on proceeding without a scale, start smaller than you think you should and then half it again just in case.

That second picture looks like an emulsion. Put it in a bowl of piping hot water and let sit til water is room temp. Repeat until the emulsion breaks. If that doesn't work, search "breaking an emulsion" for more suggestions.

Good luck.
And buy a scale!

 

[bezevo]

DITTO on GET a mg Scale . there about $15 to $30 get a 10 miligram calibration weight also ,put on sacale zero ot then weigh your product . it will help just a bit with acuracy at 5mg or higher..

good luck