• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Research e-juasca? 🌱🌿⚡

Research done by (or for) the DMT-Nexus community
Migrated topic.
Transform said:
Ah, more it was meant, had you ascertained its percentage concentration, besides what was listed on the label?
Click to expand...
Yes, definitely!

Post in thread 'DMT salts for e-juice' Research - DMT salts for e-juice

Transform said:
All the same, it seems you used some considerable excess of even 80% lactic acid.
Click to expand...
At first I wanted to use 1g of rue extract but later on thought that half a gram would be better due to a better ratio with 5ml PG. Still did add the lactic-acid for a whole gram. 😅

Transform said:
Incidentally, the ratios of the MWs provide a short cut for the stoichiometry calculation, since some things appear in both equations that cancel out when the two are combined, and all you really need to do is divide the MW of lactic acid by that of harmine, and multiply by the mass of harmine used: (90.08/212.25)*0.5=0.212203g lactic acid required...
Of course, this can be corrected using the inverse of the percentage of the acid: (100/80)*0.212203=0.265279g
and then adjusted according to the density of the acid if the percentage is w/v rather than w/w - but I don't have a figure for that! :)
Click to expand...
Thank you for that solid explanation, much easier.

Transform said:
And I do now wonder if the lactate needs to be formed before the PG is added.
Click to expand...
That's a good one to test as well!


Kind regards,

The Traveler
 
Last night I did the following:
  1. Took the mix I had made of the harmalas + PG + lactic acid.
  2. Decanted the brownish liquid to separate it from the solids.
  3. Added 1ml of VG to the liquid and mixed well.
  4. Pulled this liquid mix into a syringe.
  5. Added this liquid into a vape tank.
Result:
1708791182140.png

I tried this liquid out with a 0.2Ohm coil at 25W and to my surprise after a few puffs I felt the effects of the harmalas, the taste was not bad either!


After this I did the following:
  1. Put the remaining content of the syringe into a small shotglass (about 5ml of liquid was left).
  2. Added 1ml of PG.
  3. Added 1g of DMT-fumarate.
  4. Heated it up to 100C+
  5. Kept it heated and stirred at times until all solids were dissolved.
  6. Added 0.5ml of VG.
  7. Added 2 drops of menthol oil.
  8. Let it cool down and pulled it all into a syringe again, no solids formed when it was cooled down (also the day after it is all still liquid and no solids dropped out).
  9. Added the result to a vape tank.
Result:
1708791194451.png

I then tried out this harmalas + DMT mix with a 0.4Ohm coil (yes, no more 0.2Ohm coils left) in short bursts of 25W. The effects from this combination worked longer than DMT-fumarate alone, especially the lingering effects after the peak lasted much longer (at least 10 minutes longer).

The taste of this mix however was not the best, and now at least 12 hours after vaping I can still feel this slight bitterish taste in my mouth, no mouthwash or brushing can get it away).

Thus, in my personal opinion, it is better to take the harmalas orally and then vape the DMT-fumarate when you feel when the harmalas start working.


Kind regards,

The Traveler
 
Can you describe the effects (body and psychological) of the vaped harmala by itself? Any undesirable somatic effect? How long it hits and what exactly indicates to you that it has hit?

For me, sublingual Caapi purified harmala hits at 10-15 min with a warm feeling in the back of my neck and head. All other effects are too subtle.
 
Back
Top Bottom