HumbleTraveler
Rising Star
Performed Kash's A/B tek on 24" worth of SP (likely PC) cuttings.
Ended up with 300mg total of amber crystal.
Just now capsules were loaded up 150mg each.
Issue 1: I split up the dose evenly and weighed. The portion not on the scale was placed on a folded white piece of paper so I could just slide the xtals into the capsules.
After this was done, I noticed that the paper had brown blotty stains on it from where the xtals were sitting.
Potential overanalysis 1: Is the fact that the xtals stained the paper ok? Everything had about a week to dry out for any MEK to fully evap 30000x over if necessary. I even cold MEK washed twice just to be sure.
Issue 2: I used two blades last week to scrape my dish to transfer it to a smaller glass bowl to MEK wash. The blades which I used seem to have oxidized in some manner. The oxidation is very part of the blade and even scraping it with another blade really doesnt do a whole lot. It does powder off slightly, but it doesnt completely clean the blade.
Potential overanalysis 2: What could have caused the oxidation on the blade? Is it from the MEK touching the still lightly wet product (I did kind of chop it to promote the mek evaping).
I just want to be sure my xtals arent going to potentially wreak havoc once swallowed. Any help would be greatly appreciated :d
Ended up with 300mg total of amber crystal.
Just now capsules were loaded up 150mg each.
Issue 1: I split up the dose evenly and weighed. The portion not on the scale was placed on a folded white piece of paper so I could just slide the xtals into the capsules.
After this was done, I noticed that the paper had brown blotty stains on it from where the xtals were sitting.
Potential overanalysis 1: Is the fact that the xtals stained the paper ok? Everything had about a week to dry out for any MEK to fully evap 30000x over if necessary. I even cold MEK washed twice just to be sure.
Issue 2: I used two blades last week to scrape my dish to transfer it to a smaller glass bowl to MEK wash. The blades which I used seem to have oxidized in some manner. The oxidation is very part of the blade and even scraping it with another blade really doesnt do a whole lot. It does powder off slightly, but it doesnt completely clean the blade.
Potential overanalysis 2: What could have caused the oxidation on the blade? Is it from the MEK touching the still lightly wet product (I did kind of chop it to promote the mek evaping).
I just want to be sure my xtals arent going to potentially wreak havoc once swallowed. Any help would be greatly appreciated :d
