Lazyman's tek wielding almost nothing

[Bananaman]

SWIM just did the 2nd pull. Almost nothing! Maybe for enough for one hit. SWIM pounded the bark with wayyy more than enough NoAH and let it sit there for 24 hours. SWIM takes the extracted naphta and leaves it outside to evap with a fan blowing over it. plenty of naphta, but it evaporates into almost nothing.

any help? SWIM is using a pound of bark

 

[substasis]

it would be incredible to see lazyman's tek weild anything. i dont really know how that would work.

also, no one can give advice because you didnt give any amounts (water, lye, naptha) maybe more water would help?
also freeze precipitation ftw.

and sometimes shit doesnt pop off right. doing lots of pulls helps.

 

[Bananaman]

for the freeze percip...SWIM lets the pulled naphta evap a little and put it in the freezer right? how long should SWIM let it evap for

 

[Jorkest]

most of the time you dont realllly need to let it evap at all...it should drop...also try heating up your solution so that the temp gets to around 120 F or so...will help a lot...sometimes it take till the third pull...sometimes it just takes a few....maybe something to do with the moon..who knows

 

[Bananaman]

heating up the solution? swim already pulled the naphta out of bark

 

[1shot2]

get it in the freezer and let it evap all the way down.a small fan helps,also it can stink up your freezer so a box of baking soda in the freezer helps soak up the smell,make sure theres no food the the freezer also.or covor it.it takes a few days to evap all the way down.it will first turn cloudy and start snowing ,you may seed just a cloud,but let it evap all the way down in a chilled environment,ive had the thoughts that some water vapor from the fridge can get into evapping natha,but it quickly freezez into small drops of seed crystals for the dmt crystals to latch onto,just the vapor in the freezer should be enough to get this effect.

 

[Entropymancer]

heating up the solution? swim already pulled the naphta out of bark

Yes, but you're saying that naphtha didn't pick up hardly any DMT. Therefore it's recommended that you warm up the solution for your next pull, so that the solubility of the DMT in the naphtha will be increased.

 

[Infundibulum]

Since Bananaman already evaporated his/her naphtha and nothing was seen after the evaporation, so there is no need suggesting freeze precipitation here.

Bunk bark is not totally unheard of, yet it is extremely uncommon to get ABSOLTELY NOTHING out of it. If not anything else, he should have gotten just impurities out of the bark. SWIM's suspecting bananaman somehow managed to mess up something during the STB. so,

1) How much NaOH did he use? "way more than enough NaOH" might be too much or too little depending on one's understanding. "way more than enough NaOH" means 1 kilo or so per 5/litres of water.

2) In what volume of water?

3) Was the bark shredded/powdered or whole pieces/chips?

4) did he mix the NP solvent with the basic solution or just poured in naphtha and let it sit?

This will give more insight....

And yes, heating up the solution as Entrolymancer said can be a saviour.