• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Mescaline Tek filter size and source?

Migrated topic.

Hippie710

Psychonaut Extractor
Hey Psychonauts,

I am finishing up final touches on the Tek I am going to use for a San Pedro cactus extraction, and I am a little stuck on one part of buying lab gear. The filters, In one part of my extraction recipe calls for 6µm filters and 15µm filters later on. When looking online Im seeing lots and lots of options for material, size of paper, microns, some ranging in µm. Having a hard time finding this size and point being Im not really sure what to get and was hoping someone had a recommendation on some good filters for Mescaline HCI.

Im going off of Petes research for the purifying, found below. To help explain the situation.


Thanks,
Anthony
 
Okay that good to know, I have a lot more patience than money so I think ill bee going with a pack of the grade 3 and running it all through that. Thanks Pete, you have helped me a ton with my mescaline research.

Anthony
 
ONE more question haha, its not about filters but DMT-Nexus wont let me direct messege you and Ive made plenty odd Mescaline threads, but in in this step of your washing Tek

4. Prepare mix of dry! acetone, dry! IPA and dry! MEK (ratio 1:1:1). Mix properly and put it into freezer for a day. MEK is not necessary, but tone and IPA yes. I use all. Any water in this solution leads to lower yields

Im a little confused on the "dry!" part, Ive never done this before so this could be a really dumb question, but Im planning on buying a quart sized bottle of 99.5% Acetone and using some IPA i already have, probably just gonna use the 2 solvents this time, but am I going to have to dry out both liquids? and then how would I seperate it from the mesc if its all powder?
 
dry! means as dry as possible. So source the best you can and dry it yourself again. My acetone and ipa are the best chemists can get. I probably don't have to dry them, because the bottles come with analysis results, I can se the water is really in trace amounts. Anyway, I still dry it with dry MgSO4. More here. The same procedure for acetone, ipa and mek.
 
Re the question about "dry! acetone" etc.

how would I seperate it from the mesc if its all powder?

"Dry" is shorthand for "anhydrous" which means that all water has been removed from the solvent concerned using, most commonly, dry magnesium sulfate as pete suggests. It doesn't mean turned into a powder!
 
downwardsfromzero said:
Re the question about "dry! acetone" etc.

how would I seperate it from the mesc if its all powder?

"Dry" is shorthand for "anhydrous" which means that all water has been removed from the solvent concerned using, most commonly, dry magnesium sulfate as pete suggests. It doesn't mean turned into a powder!

Thanks downwardsfromzero, I didn't get the question, funny :)
 
Back
Top Bottom