Naptha pull is milky?

[neek]

This is my 3rd try at lazymans tek.. All previous have been successful..

But this time round, i just did my first pull and the naptha seemed clear in the pipette but then not long after being in my first jar it turned milky.. there was a tiny amount of DMT in the jar from a previous extraction.. So i pull another ml or 2 from the naptha layer in my sodium hydroxide, MHRB and naptha mix in to my mixing jug that may have minute amounts of naptha still in it.. but anyway it's clear.. but about a second later i see it start turning milky.. then bam.. it's milky.

What the??

Thanks in advance for any replies

neek.

 

[cyb]

Milky means its full of product...its precipitating already a lower temps...
Thats what you want..:thumb_up:

 

[neek]

Ahh sweet xD

Will it be worth leaving all of it to evaporate rather than filter it through a coffee filter to save for future extractions, then?

Thanks for the reply

neek.

 

[cyb]

Its best to freeze the naphtha and pour off the solvent in the morning (leaving the crystals). Dry quickly and thoroughly with a fan before it melts.
You can reuse the Nap this way...

If you just leave to evap...you will get crystals but may be coloured as this method leaves other impurities.

 

[neek]

Same process as normal then..

Thanks very much kind sir!