Gone-and-Back
Esteemed member
A while back I had done an extraction on 4ft of bridgesii cactus, performing three boils for 3 hours each. After filtering out all the cactus chunks, I placed them into a bowl and placed it into the freezer with the thoughts of doing another extraction after freezing and lysing the cells open. I didn't get that much mescaline from the first extraction, enough for a few small to moderate doses, maybe around 1.5-2g.
The last boiling that I had performed still had a very dark coloring too it, and that mixed with the amount that I got from it all makes me think that there is still some goodies in those chunks. So I am wondering if anyone thinks it worth while to try to extract from this same material again? It is still sitting in the freezer all frozen together.
If the general consensus is that there might still be some goodies left in there, I think the procedure I want to try to do is to place all the chunks onto a sheet in the oven, and dry them on a low heat. The pieces are maybe .5-1inch cubes, so they should be able to dry just fine. I however am not sure of what temp is OK to use and for how long they should be left in the oven.
Once dry, instead of doing a whole A/B procedure, I was thinking of just powdering the chunks and doing an alcohol soak with either iso or everclear, and then evaporating this to leave a tarry residue which can be eating as is. If acetone can be used, I may use that instead since I have an abundance of it at the moment.
If I go about this method, is it something that should work? Or would it be better to mix the dried cactus with lime and let dry again, and then perform pulls? Could I pull this mixture with just alcohol or acetone as mentioned before, or will that also disolve some of the lime leaving it in the finished product once evaporated?
Because of the probably small amount that may be left, I'm not trying to do the whole NP solvent pulls, acid wash, and evap that because I doubt I will even get that much and would like to do it as quickly as possible. But if that is the best way to do it then I will just do so and deal with the extra time needed for the procedure.
Thanks in advance for any input and advice.
The last boiling that I had performed still had a very dark coloring too it, and that mixed with the amount that I got from it all makes me think that there is still some goodies in those chunks. So I am wondering if anyone thinks it worth while to try to extract from this same material again? It is still sitting in the freezer all frozen together.
If the general consensus is that there might still be some goodies left in there, I think the procedure I want to try to do is to place all the chunks onto a sheet in the oven, and dry them on a low heat. The pieces are maybe .5-1inch cubes, so they should be able to dry just fine. I however am not sure of what temp is OK to use and for how long they should be left in the oven.
Once dry, instead of doing a whole A/B procedure, I was thinking of just powdering the chunks and doing an alcohol soak with either iso or everclear, and then evaporating this to leave a tarry residue which can be eating as is. If acetone can be used, I may use that instead since I have an abundance of it at the moment.
If I go about this method, is it something that should work? Or would it be better to mix the dried cactus with lime and let dry again, and then perform pulls? Could I pull this mixture with just alcohol or acetone as mentioned before, or will that also disolve some of the lime leaving it in the finished product once evaporated?
Because of the probably small amount that may be left, I'm not trying to do the whole NP solvent pulls, acid wash, and evap that because I doubt I will even get that much and would like to do it as quickly as possible. But if that is the best way to do it then I will just do so and deal with the extra time needed for the procedure.
Thanks in advance for any input and advice.
