sigmundfreuid said:
This is Jaw dropping:shock: ,i wanna smoke some of that,did you use the
erowid Pictorial tek ?
if not, would you mind sharing?Id sure love to try and extract some nice white looking Salvinorin A.
Hmm… I’m not sure if I’d try to smoke it as is. Measuring a 1mg dose is hard to do when all you have is a cheap milligram scale (as I do). Maybe measure 16mg and divide in half 4 times?
I didn’t use the erowid TEK and I’d never use a TEK that uses a room-temp solvent for the initial extraction. You’ll extract very large amounts of waxes, oils, etc. that are very hard to remove.
Salvinorin A is very soluble in acetone, even when the acetone is at 0°F. Most of the lipids in the leaf (other than chlorophyll) are not very soluble in ice cold acetone. Also, salvinorin A is present on leaf surface and not inside cells, so it is easily removed without powdering leaves.
Here’s a summary of the TEK I use (thanks to Sphere) --
1. Start with 250g or more of crushed leaves. The more leaves used, the easier it is to limit loss.
2. In batches (I used batches of 30g each), cover leaves with 0°F acetone and agitate/stir for 1 minute. Pour off acetone through a very fine strainer. Repeat 2 more times. (An extraction requires 3 minutes!)
3. Allow collected acetone to settle for 24 hours in a dark area. There will be sediment at the bottom of your container. Siphon off as much acetone as possible, being careful not to disturb sediment. Discard sediment.
4. Allow acetone to evaporate in a dark, well-ventilated area. You will be left with a bright green powder – about 1g per 100g of leaf. This powder is about 2 parts chlorophyll to 1 part salvinorin A.
5. Chlorophyll is somewhat soluble in naphtha, salvinorin A is insoluble in naphtha. Collect powder, and add about 50mL naphtha per gram, mix well. Allow to settle for several hours or overnight. Much of the chlorophyll will dissolve in the naphtha.
6. Siphon off as much naphtha as possible, being careful not to disturb sediment – the sediment is salvinorin A. Discard used naphtha.
7. Repeat steps 5, 6 two or three times – until no more chlorophyll will dissolve.
8. Chlorophyll is very soluble in isopropyl alcohol, salvinorin A is slightly soluble (0.7mg/mL). This step will remove all remaining chlorophyll, but will reduce yield especially if you use IPA liberally. Add about 50mL 99% IPA to sediment from step 6. (This will result in a loss of 35mg salvinorin A, but will remove most of the chlorophyll.) Stir, then allow to settle.
9. Siphon off IPA and repeat step 8 two more times. (Save the IPA – you might be able to get some salvinorin A out of it if you evap. it all and then repeat step 8 with the results.)
10. Add about 100mL or more acetone to the sediment. Stir. The salvinorin A will dissolve completely, some insoluble material will remain. Allow sediment to settle.
11. Siphon off acetone and put it in an evaporation dish. Discard sediment.