Stb Ratios?

[Oncewas]

28g MHRB : 16 g NaOH : 170 mL h20: 10 mL Naptha

Does that look suitable for a small scale extraction?

 

[hedcase]

28g MHRB : 16 g NaOH : 170 mL h20: 10 mL Naptha

Does that look suitable for a small scale extraction?

not enough lye...when swim does extractions he uses the ratio 1:1:15ml...then 1 ml per g..as in 50:50:750:50 ml per pull...thats just Swim though.

 

[Oncewas]

Thank you very much. Swim had a 0.1% yeild on her first attempt and the problem was entirely based on the ratio. Swim has been doing lots of research on the best ratios and may have been thrown for a loop.

So this is more adequate: 28MHRB : 28 g NaOH : 420ml H20 : 28 mL Naptha ?

Isn't that kind of a high amount of water for such a small extraction? I wouldn't know I am just curious. Thank you.

 

[hedcase]

Thank you very much. Swim had a 0.1% yeild on her first attempt and the problem was entirely based on the ratio. Swim has been doing lots of research on the best ratios and may have been thrown for a loop.

So this is more adequate: 28MHRB : 28 g NaOH : 420ml H20 : 28 mL Naptha ?

Isn't that kind of a high amount of water for such a small extraction? I wouldn't know I am just curious. Thank you.

Yup sounds about right...I wouldn't like to try to get 28 ml of naptha off...could be tough..the smallest ive done is 50g.ya the low yield is prob from not enough lye or h2o.

 

[Astralking]

My recent extraction was 1700ml water:226g of bark:113 grams of lye. Worked very well. Seems that i've got just under 2 grams from 2 pulls. I used the tek from lysergic on mycotopia but just halfed everything he used. Very good pictures from this tek which is pretty much the reason i decided to use it anyway, ratios dont seem to matter THAT much as long as the PH is high enough to get through the bark, and enough water for the "goo" to not be too thick.

Then again i am basing what i say on reading as i have only tried 1 tek but it worked!