So I've decided if I ever venture forth again it will likely be in Aya fashion as opposed to smoking the 5 minute indecipherable noise.
Most of my understanding in extraction is based on recipes that lead to smokable freebase results.
It makes sense to me that if the B were reversed with the A the end result would be a purified basic solution of somewhat purified result.
If my end result desire was an orally activated (BY MAOI ACTIVE VINE SOUTION) brew ....without using the nasty solvent method of sure pure....can I sort of acid/base/acid /// strain to produce a somewhat purified brew?
I know what it takes to make it orally active....I know that normally an A/B/Solvent method procures pure crystals....ish....eventually
I just want to make a *basically* purified ayahausca brew...
Can I start out basic then go acidic for half-ass pure...OR start acid go base and go back acid which I would think may result in a sort of emulsion that could be strained to result in a more or less purified potentiated tea or is that just resulting in a mess....considering using vinegar and sodium carbonate as A/B/...or does that make some nasty "you don't want to drink that!" concoction....lemon juice and baking soda?....not trying to make pure white....just a sort of better tea....the traditional method is just boil a crap load of plant material so just trying to reduce the needed intake volume.
Finally...in terms of usage of Caapi LEAVES for a primary tea....what sort of dosage yields adequate results?
I know typically the vine meat is used but can leaves create a tea with enough MAOI quality to facilitate oral DMT absortption?
Most of my understanding in extraction is based on recipes that lead to smokable freebase results.
It makes sense to me that if the B were reversed with the A the end result would be a purified basic solution of somewhat purified result.
If my end result desire was an orally activated (BY MAOI ACTIVE VINE SOUTION) brew ....without using the nasty solvent method of sure pure....can I sort of acid/base/acid /// strain to produce a somewhat purified brew?
I know what it takes to make it orally active....I know that normally an A/B/Solvent method procures pure crystals....ish....eventually
I just want to make a *basically* purified ayahausca brew...
Can I start out basic then go acidic for half-ass pure...OR start acid go base and go back acid which I would think may result in a sort of emulsion that could be strained to result in a more or less purified potentiated tea or is that just resulting in a mess....considering using vinegar and sodium carbonate as A/B/...or does that make some nasty "you don't want to drink that!" concoction....lemon juice and baking soda?....not trying to make pure white....just a sort of better tea....the traditional method is just boil a crap load of plant material so just trying to reduce the needed intake volume.
Finally...in terms of usage of Caapi LEAVES for a primary tea....what sort of dosage yields adequate results?
I know typically the vine meat is used but can leaves create a tea with enough MAOI quality to facilitate oral DMT absortption?
