• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Vape low dose freebase slowly

what effect does vaping slowly have for you?
you could try using a cigarette tar guard filter...but it would trap vapor tars and some of the dmt molecule itself resulting in way less vapor volume..
.using a cigarette filter .. with dmt freebase results in very low dose results..
you could get a desk vape like the ,,,,stores and bickel... volcano...it is a slow vaping machine.... and it makes very high quality vapor..close to 100 percent purity ...that purity is cleaner vapor.. but can be surpisingly strong . depening on dosage...
 
Last edited:
I'm looking to take slow, low doses to be able to get anxiolytic and antidepressant effects from dmt without breaking through.

I probably will go the e juice route, was just wondering if there was a way to do it with freebase to avoid extra chemicals.

I'm yet try try dmt and not wanting to spend the amount a desk vaporiser would cost to find out if it works for me. But thank you for the suggestion and it's something I will consider if dmt works for me.
 
I just have a separate coil for my wax pen style vape I typically use for cannabis concentrates. I find with more orange waxy DMT it’s easy to melt a few mg into a warm coil and then use whenever similar to shatter etc.
 
Dab cart, I found that a tiny amount the size of a pin head was enough to give strong oev's.
Sorta like taxing around the airport but staying away from the runway.
Its not the "oil cart" with the full chimney, but the shorter one with the tiny spoon as part of the mouth piece.
My original plastic mouth piece cracked so it was replaced with a vape driptip.

Dont just toss freebase crystals in it cause they will probably drop out the airhole, heat it up with a pulse and drop the pieces on the ceramic coil
against the side where they should stick.
I was using the brown/red goo so it just stuck to the spoon which is also alright.
dab cart.JPG
 
I'm looking to take slow, low doses to be able to get anxiolytic and antidepressant effects from dmt without breaking through.

I probably will go the e juice route, was just wondering if there was a way to do it with freebase to avoid extra chemicals.

I'm yet try try dmt and not wanting to spend the amount a desk vaporiser would cost to find out if it works for me. But thank you for the suggestion and it's something I will consider if dmt works for me.
If you want to avoid extra chemicles...you certanly dont have to use the E juice...Just vape the freebase .. by itself.... in a micro dose....Use E mesh vape to do this...
I built my own convection E mesh from the origional conduction E mesh....



True E mesh convection !. and ceramic health stone ..
2 3 4
 
Do you think you can elaborate a bit on that device - I am super unfamiliar with these things. This would screw on a mod box like the Aegis Solo? And then you simply load up the spice and you can take continuous small tokes?

I like to do MAOI enhanced trips and like to take small tokes of like 1mg a time - like toke, wait couple minutes, toke again, wait, toke, wait, etc...
 
Do you think you can elaborate a bit on that device - I am super unfamiliar with these things. This would screw on a mod box like the Aegis Solo? And then you simply load up the spice and you can take continuous small tokes?

I like to do MAOI enhanced trips and like to take small tokes of like 1mg a time - like toke, wait couple minutes, toke again, wait, toke, wait, etc...
Yes it will attach to the Aegis Solo. I am not sure if you can have multiple tokes from it. It is a small ceramic bowl where you place your freebase. Possibly if you place like 20-30mg in it and heat a little bit you might take a small toke from it, and than another one.... and another.... it has quite restricted airflow, so for me to evaporate whole 20-30mg at once takes usually 30 seconds of toking.... and before i end with my toke i allready start to feel teh effect.... so i assume that if you heat a little bit, and inhale for 10 seconds you will evaporate much less.... you woukd have to be carefull to heat it just a little bit.

 
My first extraction resulted in a lot trims than I was hoping for so instead of a low dose once a month I have made a very weak e liquid and will try micro dosing with this.

Anyone got any positive experience with this?

I'm hoping so as I don't want to try to re extract it from the Pg e liquid or do another extraction from bark as my first wasn't very successful.
 


Write your reply...
Back
Top Bottom