I have had 3 extractions (100g, 100g, 50) so far using the same cybs salt tek, that I always use that produced nice looking white crystals. Only issue is it has no effects and I am well aware of over heating it. Is there something that stands out to anyone with more knowledge than me? Sorry for lack of detail
-
Members of the previous forum can retrieve their temporary password here, (login and check your PM).
White crystals but has no effect?
- Thread starter gloss0rzz
- Start date
30mg and using a Yocan Orbit on lowest voltage.
This is odd. Do you take in any medication that might be affecting your serotonin receptors? Any SSRIs?
This. Plus, do other psychedelics have an effect on you? Has DMT ever had an effect on you before?
No medication, and DMT most definitely works. It has my respect for sure. Is there anything else that would crystal up the same as DMT after freeze precipitation? It looks and tastes like its legit, but I cant seem to get any effects from this particular yield.
Actually havent had any in over a week, until these last few extractions. Im just worried that im extracting something else. I seem to have problems with the white more than later pulls that are more yellow.
Then, it sounds plausible that it may be more about you than the result of the extractions.
Do you have any DMT from a previous "confirmed effective" batch, to try and compare?
From the information provided it sounds like a skill issue with vaporization. This is the most common form of a failure to launch and if it makes you feel any better, more of us than not have had the same growing pains. You'll get there. For me, putting DMT with mullein into a rolling paper is a very reliable method. I will assume that you are aware of and have been attentive to the necessity of holding your hits in for a long time. 10 seconds is an agreed-upon standard, though slightly less time may also work.
