first extraction

Gender: male Age 19 Weight: 177.3lbs Height: 5’8” Dose (ACRB):8ish hits of a 2.5-3:1 ratio of pg at 3.4v roughly 40mg Dmt (FB) (I had only been micro dosing prior to get a feel and hoped for neuroplasticity increases) Setting: even though it was my first trip I decided to do it during a...

PsiFractal here of NW GA. A bit about me: I’m a businessman with a desire to wear anything but a suit. Consciousness and mindfulness are my two main concerns in life, not the money. I’m a car nut through and through, I own a Veloster N that’s FBO with a hybrid turbo and I’m currently...

Hi all, I have recently performed my first harmalas extraction by following this tek and, unfortunately, I ended up with rather low yields, so I'd like to understand how I can do better next time. In short, I used 100 g of Syrian rue and I got only 500 mg yield out of it, which is 0.5%. I was...

First pull image

Hi all, I recently ran an extraction process which I screwed up, so I'd like to do a bit of a post-mortem to make sure I learn from this and I might potentially still need to finish it off properly. Here is the process that I followed: Mix (until water was clear) 100 g of lye in 750 ml of...

I’m new to the extraction side of things, but my journey with DMT started about 8 years ago when I was 19. Back then, I managed to go through a whole gram in just three days. That experience completely changed my perspective... I was fascinated to discover that a dimension like that actually...

So I wanted to document my first dealings with MHRB bark extraction. I read all of the teks on the wiki and didn’t wanna stick to one buying a million different solvents etc. I kinda just wanted to see how it would work if I threw it all together and these are my results as well as my technique...

i recently obtained 200g of mimosa rootbark i have no psychedelic experience before just smoked couple of blunt and get drunk any tips or sugestions firends?

Hello everyone, This is my first time performing an extraction. I placed my glass tray with the solvent (Zippo lighter fluid) in the freezer, and after 4 hours, I checked to see if everything was going well (I know it should stay there for a total of 12 to 24 hours). In the picture, you...

Hi all! finally gathered all my supplies and felt confident enough in all of my obsessive research from the last 2 weeks to attempt my first extraction. I'm pretty ecstatic w/ the result so far and figured i'd share. i had thought i'd settled on my tek 2-3 times before finally deciding to go...