Acacia Confusa Extract (Cyb's TEK)

[Neo-Shaman]

Hello everybody!

Recently did a Acacia Confusa extract using Cyb's Tek (Cybs' Hybrid ATB 'Salt' Tek - DMT-Nexus Wiki)

I followed everything to a 'T' an was rather disappointed.

Here some pics of the processes.

 

[Neo-Shaman]

I'm disappointed not simply because I got goo, that is fine, but because of the extremely small amount in which was scraped up after freeze precipitation.

I started out with one jar using 100g of Acacia Confusa but underestimated to overall volume of the liquid so I ended up moving half the contents to a second mason jar treating both containers as if two separate 50g extractions.

It looks like there is a a lot of yellow/orange goo in the first freeze precip jar but what is in the test tube is all that was scraped out of it. As well as it being heavily contaminated. Me holding the test tube is a pic of the contaminated goo of the first pulls off each jar.

I then did two more pulls off each jar hoping to get more but got the same result an extremely small amount of orangish goo which I then placed on some tin.

Does anybody know what is causing the extremely small amount that I'm Pulling?

If not does someone know any Acacia extractions that work extremely well? I'm planning on using joshisom's tek next time (Welcome to the DMT-Nexus)

 

[Hieronymous]

Maybe the bark you have doesn't have much mojo in it.

Cyb's tek is a proven performer for ACRB, most people are getting clean white crystals from the first pull and sometimes the second as well. It's the later pulls that tend to have a higher oil content.

By all means try another tek, but if that yields a low amount or has a high oil content then you will have to suspect that it's the bark.

 

[HumbleTraveler]

Yes Ill certainly vouch for Cybs tek and ACRB, beautiful yields.

Id certainly point a finger at your bark since you followed it perfectly.

You know whats funny IME, my later pulls are always more saturated. I couldnt explain why, but my 1st is usually light, the 2nd and 3rd are heavy, and after that its just useless to pull.

One thing Id like to point out is the importance of NOT heating the mixture, so much as warming it. And prewarming the naphtha that you add too has seemed to have good use in my book. You dont want everything to sit too long either, the quicker your pulls the less oils and fat you will get. Also, the quicker you get everything into the freezer the more pure white the xtals will be, BUT you can get larger crystals by cooling everything as slowly as possible.

 

[Earthwalker]

Yeah you got bunk my freind , pic no 3 looks just not right for some reason. looks like a kilo ,of bunk aswell , I've been down this road plenty of times before I finally listened to the advice of fake bark ( bunk ) , I always thought it's my fault that it didn't work out ,
Ie: not enough heat , the chemicals I was using , I blamed everything except the bark , aslong as you follow the simple rules of Cybs TEKs, like correct ph ,salting , warm water baths , etc you can't go wrong that's the beauty about Cybs TEKs there just strait forward easy and even has pics for us mentally challenged !

Change you're bark ! Stick with Cybs TEK , and it'll happen I promise you that , I constantly average 1.2 - 1,5 % everytime with these TEKs , and I get bright white crystals every time no goo ,,

Stick it out and youlle be rewarded I garrentee !!

Good luck :thumb_up:

 

[Psychoactive Haven]

Acacia usually seems to be darker then that.

 

[Infectedstyle]

I get the same problem tho. Miniscule yields. I used MHRB and ACRB 50g on two seperate ocassions and both had maybe 50mg yields total.

I find it hard to believe i got bunk MHRB and ACRB. Especially considering that on both pulls there was a tiny yield so apparently something is in there.

I'm wondering if it is perhaps the vinegar I have been using or some of the salt since i've gotten bigger yields from the same MHRB. But I just think it is weird overall. I don't seem to be doing anything different than the tek implies. Although I did neglect some of the initial freezing/vinegar on ocassion so i will try doing that more thoroughly next time and use more naoh.. But that never got me far in the past.

 

[Earthwalker]

I get the same problem tho. Miniscule yields. I used MHRB and ACRB 50g on two seperate ocassions and both had maybe 50mg yields total.

I find it hard to believe i got bunk MHRB and ACRB. Especially considering that on both pulls there was a tiny yield so apparently something is in there.

I'm wondering if it is perhaps the vinegar I have been using or some of the salt since i've gotten bigger yields from the same MHRB. But I just think it is weird overall. I don't seem to be doing anything different than the tek implies. Although I did neglect some of the initial freezing/vinegar on ocassion so i will try doing that more thoroughly next time and use more naoh.. But that never got me far in the past.

The freeze thaw ain't gunnaake such a huge differance in 50g batches for you to notice the diff ! Why do you say it's the vinegar or salt ?? And if you're bark is from the same tree all the time I can't see how it can fluctuate that badly as you discribe !
Also just because you get MHRB don't mean it's not bunk either !!

 

[Entheogenerator]

Earthwalker, please edit your post to remove the question about purchasing. Then I might suggest that you re-read The Attitude Page. :!:

 

[Earthwalker]

Done

 

[starway6]

Yeah you got bunk my freind , pic no 3 looks just not right for some reason. looks like a kilo ,of bunk aswell , I've been down this road plenty of times before I finally listened to the advice of fake bark ( bunk ) , I always thought it's my fault that it didn't work out ,
Ie: not enough heat , the chemicals I was using , I blamed everything except the bark , aslong as you follow the simple rules of Cybs TEKs, like correct ph ,salting , warm water baths , etc you can't go wrong that's the beauty about Cybs TEKs there just strait forward easy and even has pics for us mentally challenged !

Change you're bark ! Stick with Cybs TEK , and it'll happen I promise you that , I constantly average 1.2 - 1,5 % everytime with these TEKs , and I get bright white crystals every time no goo ,,

Stick it out and youlle be rewarded I garrentee !!

Good luck :thumb_up:

I wouldent call it bunk untill i tryed some..
I have gotten nice white crystals through simple evaporation before..
But recently its more waxy but nothing bunk about its effects!
Its been long known that acacia goo is very potent..and just like melted crystals...
Try some first..then make judgment...

 

[Infectedstyle]

I get the same problem tho. Miniscule yields. I used MHRB and ACRB 50g on two seperate ocassions and both had maybe 50mg yields total.

I find it hard to believe i got bunk MHRB and ACRB. Especially considering that on both pulls there was a tiny yield so apparently something is in there.

I'm wondering if it is perhaps the vinegar I have been using or some of the salt since i've gotten bigger yields from the same MHRB. But I just think it is weird overall. I don't seem to be doing anything different than the tek implies. Although I did neglect some of the initial freezing/vinegar on ocassion so i will try doing that more thoroughly next time and use more naoh.. But that never got me far in the past.

The freeze thaw ain't gunnaake such a huge differance in 50g batches for you to notice the diff ! Why do you say it's the vinegar or salt ?? And if you're bark is from the same tree all the time I can't see how it can fluctuate that badly as you discribe !
Also just because you get MHRB don't mean it's not bunk either !!

Hey, sorry for the late reply. I only thought it was the vinegar or salt because it is the only thing I added since changing up from "DMT for the masses" tek to "Cyb's tek". But that outcome seems very unlikely.

I'm not sure if it is from the same tree but from the same Removed No talk of sourcing

 

[Entheogenerator]

Done

Thanks

 

[Sabnock]

I personally don't see why people bother with extracting crystals and such. Enhanced leaf is by far the better way to go, and one can get smokeable DMT easily with washing soda and 99% Iso, though it will be full spectrum, but still, full spectrum IS smokeable DMT.

 

[Earthwalker]

I personally don't see why people bother with extracting crystals and such. Enhanced leaf is by far the better way to go, and one can get smokeable DMT easily with washing soda and 99% Iso, though it will be full spectrum, but still, full spectrum IS smokeable DMT.

I to am a enhanced leaf lover , all my crystal I turn into E/L it's just so easy to smoke , I don't save crystals for vaporising and goo for enhanced leaf as I don't get any goo from my acacia as strange as it sounds !

 

[Neo-Shaman]

Thanks for all the help guys. Might I add that a friend and I smoked the goo to no avail. Not a damn visual whatsoever. :x

 

[Earthwalker]

Thanks for all the help guys. Might I add that a friend and I smoked the goo to no avail. Not a damn visual whatsoever. :x

Sorry to hear that but That's because it's not active , that's the final stamp of approval that you got bunk my Freind !!:thumb_dow

 

[garlictrain]

Greetings and blessings!

For reference here is some ACRB A/B xtals SWIM gifted me recently!

All about having a reliable source of ACRB.

Idk the source but I do know SWIM looked long and hard and has dealt with poor yielding ACRB.

Stay the path and you will be blessed!

Good luck friends!

Love and light!

 

[dimitrii]

I'm currently performing the same tek, and I got a lot of orange goo that looks identical to what you have there. However, I am starting to see more dmt crystals embedded in the goo as I do more pulls, so I still have hope that I only got semi-bunk ACRB. I really miss the days of easy to find high yield MHRB.