spaceshuttle
Rising Star
- Merits
- 42
was doing a re-x, boiled some water, added the naptha until it was heated to about 50c (120F). but the dmt wouldn't fully dissolve so back into the water and turned the heating pad back on, an unrelated situation occurred, causing loss of attention. so the naphtha ended up boiling, immediately turned off the heat and removed from water. there was a small brown bit on the bottom (burnt dmt? or oils?)
let cool to room temp and then the oils and dmt saturated naphtha separated, removed the oil and put it in the freezer thinking it was ruined. but 36hrs later, the crystals where whiter than white, they where clear!
400% better results than previous re-x's.
it is unknown if yield was lost because original wasn't weighed.
so basically the question is, what is an ideal temperature for re-dissolving dmt into naptha?
iv done a search but cant find specifics? is it even critical? just hot enough to dissolve it? and then let oils and dmt separate?
let cool to room temp and then the oils and dmt saturated naphtha separated, removed the oil and put it in the freezer thinking it was ruined. but 36hrs later, the crystals where whiter than white, they where clear!
400% better results than previous re-x's.
it is unknown if yield was lost because original wasn't weighed.
so basically the question is, what is an ideal temperature for re-dissolving dmt into naptha?
iv done a search but cant find specifics? is it even critical? just hot enough to dissolve it? and then let oils and dmt separate?
