Any goodies still left in here?

[spyfish]

Did a extract of 100g MHRB, last two times ive had allot of fat in it so I did a mini A/B after. But I think I have been using to high temp, so more fat. This time i kept the water bath at 50C.

Anyhow, I did 6 pulls on the mini A/B. And the result got milky white in the pyrex dish and now in freezer. However the Mini A/B base soup is still milky, and once it cooled down allot fo white stuff seem to solidify and fall to the bottom.

This gotta be spice right?

Last time I did a mini A/B the base soup was almost clear after 5 pulls. I am curious as to how much I will have from the freezer tomorrow?

Could this be something else than spice im seeing? By the way, Im using Cybs salt hybrid tek.

I ran out of time so I stopped at 6 pulls, had planned to drink aya tonight (which I just did)

 

[Tryptallmine]

Just warm it up again and do another pull when you get the time, if there is DMT in there it'll migrate to the solvent. If not its probably spent. 6 pulls is usually pretty thorough. I generally find 4 is enough for me before it becomes fruitless.

I've seen a white precipitate fall out to the bottom of the vessel before, it wasn't DMT though. Couldn't identify it. You could break it up though by warming the soup.

 

[spyfish]

I think you are right, there was 2.2 g of yellow fluff/goo from 6 pulls.

But I dont get why I get so much fats with, even after a mini A/B.

Is it my MHRB that is extra ¨fatty", its the third extract of the same bar with similar result.

Trying now with some powdered ACTB.

I plan to use this for Changa anyway, so the yellow goo should be good right?

 

[concombres]

Possibly old bark or too much heat.
Try a few re-x`s with warm solvent.
If the yellow comes over, the solvent is too warm.
It should pick up white & leave a yellow blob at the bottom, but you can work with small amounts (10ml) at a time to slowly pick up the white spice from the yellow oils without pulling too much into it.

 

[spyfish]

Thanks I ended up dissolving it in alkohol and add it to changa mix. 2.2 g leaves (Caapi and lemon balm) and 500 mg harmala freebase.

I´m doing another extract now with ACTB. Interestingly the naptha was more yellow, but after back-salting it is perfectly clear. The pulls with the mini A/B are clear as mountain water.

I think i might have been using too much heat when pulling, and too little heat when back-salting.

But I also think the MHRB was especially ¨fatty¨, make a very good Aya analog though

 

[Tryptallmine]

My rule of thumb with heat is this...if it's that hot that you can't hold the vessel with your hands then its too hot. It only needs to be 40-50degrees, doesn't matter if it gets a bit colder just reheat it a little but no need to boil the life out of it.