Apx volt v3 atomizer review

[HonkyCat]

I know it is an older device/method and been discussed before, but wanted to give an updated, fresh review...

I just got the atomizer along with the bubbler attachment as I had a mod already. With the bubbler removed, I dropped my dose in the quartz bowl, gave it a few quick presses at 3.0v to melt, then reattached bubbler. I held the button for a few seconds, released and then pressed again while starting my inhale. It gave me a nice, milky white vapor that was consistently thick, as if one filled up a big clear glass bong. The vapor got warm, but nothing near untolerable and taste wasn't strong if at all. The buzzing began mid breathe-hold and I held it for about 9 seconds total, pressing the button periodically just to keep it warm and went for another. Midway through the second pull a pattern began to envelope my vision, I took the same size pull and held it about the same. When I blew out, I almost couldn't see the room I was in due to how strong the buzzing and pattern in my vision got and felt like I was about to go unconscious so I didn't go for a 3rd, just laid back and closed my eyes.

It took me where I wanted to go, and nothing about the experience pre trip was difficult, honestly about as simple and convenient as it gets.

 

[yatyas314]

was it a new atomizer or one you had previously used?

 

[HonkyCat]

was it a new atomizer or one you had previously used?

New, cleaned with qtip and alcohol afterwards and it's been used multiple times since with same success.

 

[yatyas314]

I am a ypcan guy, but I just ordered the setup you described. I will report back when it arrives.

 

[HonkyCat]

I am a ypcan guy, but I just ordered the setup you described. I will report back when it arrives.

Awesome! Please do, Ill answer any question you may have. Gonna attempt here to really breakdown the method I used.

The atomizer came fully assembled with it's own glass mouthpiece installed, I removed it by sliding it off.

Installed the atomizer onto my box mod. My mod uses wattage for its main adjustment, by when you fire the button, it shows voltage on the lower right, so I fired it and adjusted wattage till I found 3.0-3.2v.

I admittedly didn't measure out my first dose. I did measure on the others and it didn't seem to make a difference in use or effect, but I'm sure if you went as low as 20mg then your experience would be less. I used a folded card to dump some into the quartz/glass bowl until it was almost full, then tapped the button for a split second a few times to melt it down.

I installed the bubbler attachment and began a few inhale/big exhales of fresh air to prepare.

I held the button down for about 3 seconds while doing my last big exhale, released the button and pressed again and starting my first pull from device.

If you look down, you should easily be able to see the bubbler, and it should no longer be see through, but full of thick white vapor. The apx volt v3 isn't as free flowing as a typical nic vape, but it allows you a great balance between wide open inhale and a difficult pull. Just a light resistance.

When I was almost filled up, I backed off and took a hit of fresh air and held, the whole time I was holding the vapor in I kind of pulsed the button in the same manner as when I was melting it down before, just to keep it warm.

Held the button down and took another hit, almost as long as before but not quite. My reasoning was I knew it was on its way and wanted some time to hold it all in. In hindsight, probably could've just kept inhaling on the second one, not worrying about holding it in.

Three different people have used mine so far, none have been able to get a third in. One of those people have used all kinds of pipes/vape methods, and they said it matched the strength of their favorite method (regular dab rig) only much easier and safer to use. They're ordering their own now.

So far this is my recommendation for blasting off. I want to play around with dosages and voltage to see what else can work for maybe lighter experiences, but haven't yet so I can't offer any guidance there.

I hope this is formatted and described in a way to make it as easy as possible to follow. Please let me know how it goes!