• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Apx volt v3 atomizer review

First time I've seen it, and I'm positive it would work great but man it's expensive 🤣 I like that there's no coil/cup to go bad and have to replace (unless the glass breaks but that's another matter.)
Would you just load freebase in or need to make into an oil?
 
Would you just load freebase in or need to make into an oil?
Apx volt v3 = freebase, the device that yatyas was referring to is also freebase though one might could use oil in that. It's an electric dab rig, so would work for freebase as well as thc concentrates.
 
The volt looks good, I sat and stared at it for an hour loaded and pre melted just was not the right night. One thing I wanted to ask you was without the glass mod have you tried it with the stock mouthpiece? there is an air adjustment I am curious if you have any experience with that ?
Y
 
The volt looks good, I sat and stared at it for an hour loaded and pre melted just was not the right night. One thing I wanted to ask you was without the glass mod have you tried it with the stock mouthpiece? there is an air adjustment I am curious if you have any experience with that ?
Y
I haven't tried it with the original mouthpiece. As far as I know the only way to adjust air is to mod the small holes along the base of the atomizer and I haven't attempted that, don't wanna mess it up.
 
I know it is an older device/method and been discussed before, but wanted to give an updated, fresh review...

I just got the atomizer along with the bubbler attachment as I had a mod already. With the bubbler removed, I dropped my dose in the quartz bowl, gave it a few quick presses at 3.0v to melt, then reattached bubbler. I held the button for a few seconds, released and then pressed again while starting my inhale. It gave me a nice, milky white vapor that was consistently thick, as if one filled up a big clear glass bong. The vapor got warm, but nothing near untolerable and taste wasn't strong if at all. The buzzing began mid breathe-hold and I held it for about 9 seconds total, pressing the button periodically just to keep it warm and went for another. Midway through the second pull a pattern began to envelope my vision, I took the same size pull and held it about the same. When I blew out, I almost couldn't see the room I was in due to how strong the buzzing and pattern in my vision got and felt like I was about to go unconscious so I didn't go for a 3rd, just laid back and closed my eyes.

It took me where I wanted to go, and nothing about the experience pre trip was difficult, honestly about as simple and convenient as it gets.
Ive been trying with the bubbler and im
Using like 10-20 mg, but every time i try to inhale for longer than 5sec its so irritating and i have to stop inhaling or else ill cough. I also seem to always have so much vapor left after i though i was done. Ill do 2-3 inhales then ill take the bubbler off and ill hold the button to see that there was like 10-20 seconds more vapor left. Im doing this on 2.8v typically bc anything higher i cant really handle at all
 
Ive been trying with the bubbler and im
Using like 10-20 mg, but every time i try to inhale for longer than 5sec its so irritating and i have to stop inhaling or else ill cough. I also seem to always have so much vapor left after i though i was done. Ill do 2-3 inhales then ill take the bubbler off and ill hold the button to see that there was like 10-20 seconds more vapor left. Im doing this on 2.8v typically bc anything higher i cant really handle at all
Try Inhaling harder. It sounds counterintuitive, but the more air you draw through it, the cooler the vapor will be which may be easier on your throat and lungs.
 
Back
Top Bottom