KateAdam
Rising Star
Hi all
I know I dont tend to post on here very often and tend to wall flower more.
I've followed Cyb's Max Ion tek a number of times with MH from different sources and still consistently getting low results, normally about .8g from 100g of material. I'm at a bit of a loss of where I am going wrong.
I'm more than happy to write in detail on the extraction if it would be useful, I am wondering though if it could be the acid base part of the extraction. I am using vinegar to acidify but only managing to get the solution down to about ph3.4, is this enough.
I am thinking about using phosphoric acid next time, does anyone foresee an issue with this or should I be trying a different acid?
Grateful for any thoughts, I am at a loss.
Thanks
Kate xx
I know I dont tend to post on here very often and tend to wall flower more.
I've followed Cyb's Max Ion tek a number of times with MH from different sources and still consistently getting low results, normally about .8g from 100g of material. I'm at a bit of a loss of where I am going wrong.
I'm more than happy to write in detail on the extraction if it would be useful, I am wondering though if it could be the acid base part of the extraction. I am using vinegar to acidify but only managing to get the solution down to about ph3.4, is this enough.
I am thinking about using phosphoric acid next time, does anyone foresee an issue with this or should I be trying a different acid?
Grateful for any thoughts, I am at a loss.
Thanks
Kate xx