cinderblock
Rising Star
- Merits
- 42
I found this following information on this website, but I noticed no tek employed these steps, so I figured I'd ask to gauge the response from the experts. Maybe this outdated info... but basically, these steps are to be taken to clean your DMT of possible lye contamination. To do so, you need sodium carbonate, apparently.
Afterward, now that you're sure your DMT crystals don't have any lye, it recommends another step to clean it of toxic solvents (naphtha trapped in the crystals)... this time, you either need "ethanol or IPA/Acetone," according to the following steps. I am not sure how much ethanol you need though. It's not explained, and I haven't found any other info on cleaning your DMT with ethanol. And by "IPA/Acetone," I'm assuming it means "Isopropyl Alcohol/Acetone?" So is that a mix of two ingredients? If so, it would be a lot easier to procure just one ingredient Ethanol for this procedure.
Have your product still in the solvent, before evaporation/precipitation. If you have already in crystal form, redissolve in a naphtha/heptane/hexane.
Add anywhere in between a pinch to 5 grams of sodium carbonate (yes, doesnt matter... All that is necessary is for it to be a basic solution) to 100ml clean water.
Add your spice-containing solvent and the sodium carbonate solution together in a container. Mix/shake/whatever (emulsions will not form).
Separate the solvent from the sodium carbonate solution using pippette/turkey baster/syphon/separatory funnel. One can repeat steps 2-4 if desired, but not strictly necessary
Freeze precipitate or evaporate to retrieve your DMT
Afterward, now that you're sure your DMT crystals don't have any lye, it recommends another step to clean it of toxic solvents (naphtha trapped in the crystals)... this time, you either need "ethanol or IPA/Acetone," according to the following steps. I am not sure how much ethanol you need though. It's not explained, and I haven't found any other info on cleaning your DMT with ethanol. And by "IPA/Acetone," I'm assuming it means "Isopropyl Alcohol/Acetone?" So is that a mix of two ingredients? If so, it would be a lot easier to procure just one ingredient Ethanol for this procedure.
Remember that regardless of washing, its still very important to make sure there are no solvent traces in your spice, which can be done with thorough air drying, or redissolving your dmt in a non-toxic (or less toxic) solvent like ethanol, or pure IPA/Acetone, and evapping that again
search for "washing"