euclyptus oil

[deemster414]

hello, i have used this oil it pulls full spectrum dmt i believe, My first test was in a naptha exhausted solution.2nd test was in fresh 50gram extraction stb. The oil pulls dmt at room temp, but holds alot more when warm (not sure yet how much) I have been trying to freeze preciept it out but suspect that i need a colder freezer, cause i am seeing thick cloudy formations but it has been in the freezer for a week now. I am going to try dry ice next to see if that will help. Salting with fasa works and produces clear fumerate crystals. I am waiting for them to dry now then i will convert to fb. eucalyptus oil is available at walgreens for like four bucks for 60ml. I have tested this with mimosa hostlis.

 

[Parshvik Chintan]

i don't think you can freeze precip with oil..
also, why eucalyptus oil instead of a cheaper more accessible vegetable oil?

 

[DreaMTripper]

Hes just experimenting I think...Hot Sunflower oil is very good at pulling but creates an impenetrable emulsion..a dmt jail..

 

[deemster414]

i am just experimeting to find a way to get full spectrum freebase crystals withoout the hassle of salting and then basing and pulling with acetone. this was my first oil tested and wanted to share the results.

 

[DreaMTripper]

Acetone is no good for np in wet teks maybe a drytek is what youre after. You could pull with euc oil and salt it with vinegar then freebase by way of heating the solution on low to evap off the water and vinegar which breaks the acetate bond leaving freebase.
Its a long heat sensitive fumigating process but will result in very pure dmt.

 

[TriAngleOptics]

You can try whatever you want buut VM&P is always clean, fast, and most pull.

 

[deemster414]

I am trying to find an alternative to salting out full spectrum spice from MHRB, the way i have been getting full spectrum spice is to add water to lye, then add bark, wait for an hour, add either xylene, d-limone, or in this case eucylptus oil. Then I salt them out with fasa then rebase with sodium carbonate and pull with acetone then i evaporate the acetone.

I will try salting it with vinigar, to see the results, but I really want to find a way to not have to salt out the alkoids.

 

[deemster414]

You can try whatever you want buut VM&P is always clean, fast, and most pull.

yes naptha works good I use it all the time, but it doesnt get everything cause you can add xylene or d-limone or eucalyptis oil to any naptha exhausted slurry and still pull out goodies. i dont want just freebase dmt i want full spectrum freebase dmt.

 

[Parshvik Chintan]

I will try salting it with vinigar, to see the results, but I really want to find a way to not have to salt out the alkoids.

then you would have to go with xylene or toluene or some aromatic hydrocarbon that evaps clean.

otherwise you gotta salt it out, but i don't see what is wrong with that.