• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Extracting 5-MEO-DMT

Migrated topic.
The first problem is finding some virola resin that has good 5-MeO-DMT content in the first place... Apparently a lot of what is sold commercially has very low alkaloid content.

If you do find, a simple A/B extraction like with DMT should work. Maybe dry-basifying resin, pulling with acetone and adding FASA could work, to get fumarates. So far there have been very few if any reports of 5-MeO extractions, so its hard to say. There was some time back where 69ron suggested maybe hydroxide bases could damage 5-MeO-DMT, but ron also made several other dubious claims, and I dont think there's any chemical reason for that. In any case you could try using a base such as sodium carbonate, specially if you do a dry pull.

As for solvents, most, if not all, solvents used for DMT should work. In literature, petroleum ether (equivalent to naphtha) is used for the final crystallization, so 5-MeO should be soluble in it, though not very much.
 
Noman said:
Oddly enough, this:
showed up on Erowid a few days ago, authored by our old friend Baron.


he also slipped in a mention "Dibufotenoxide" just for me.... knowing I am always teetering on the edge of attempting yet another bufo extraction

probably not, but I am always teetering on the edge of attempting yet another bufo extraction.... and I have pinned the scapegoat tail on ron

good luck OP
 
Back
Top Bottom