Voidmatrix said:
Mushie_Man said:
Voidmatrix said:
Mushie_Man said:
Thanks brother, you are very good. I can save so much lye now lol
I've been meaning to try out even less than that, just to see. Worst case scenario, I add more lye later.
One love
I have a pH tester. I think it was only 15 euros. I will use it and see how much lye it takes to reach pH 13 and let you know
I forgot that I do too :lol: Done enough that I haven't pulled it out in a long time.
One love
This is my own tek I have developed over time, what do you think? Is this clear enough? I am working on turning it into a video for my channel. I had the 'Mushie_Man Tek' on YT but they took it down and struck my channel but it's up on Bitchute. I have made many improvements since that video and want to make sure the next video is clear for all to follow:
- Add 100g Mimosa Hostilis Root Bark (powdered) to a 1L Borosilicate glass mason jar (clip-top).
- In a separate borosilicate glass (Pyrex) measuring jug measure 750ml of water (I use de-ionized water), add the lye (I use around 40g) to 750ml de-ionised water slowly as a violent chemical reaction occurs and creates a high pH solution and high temperature. We need a pH of 12 or above to break down the cell walls of the bark and release the molecule into the base, so keep adding the lye in small increments and stirring until dissolved or the desired pH is reached (the mixture should turn clear when fully dissolved). Remember to use a stainless steel spoon here so it doesn't get dissolved into your mixture. Allow to cool to room temperature before adding to the powdered bark (this helps to create whiter crystals).
- Mix your cooled-down (room-temp) lye water into the powdered bark (I like to feel the outside of the jug with my hand but you can use a thermometer also). Be careful not to splash it on you and always wear gloves, eye protection and even a face mask to help prevent harmful fumes from being inhaled. Mix until the bark is fully saturated and no dried bark is floating on the top. Take your time with this part and make sure it's done correctly.
- Once you are happy that your base is fully saturated, add your solvent on top. Mix (don't shake) softly for about 10 minutes and let sit for 30 minutes. We are just making sure that every bit of the base has been in contact with the solvent to rip away that molecule. Repeat this process 7/8 times to ensure the solvent has extracted the DMT molecule into it. I like to use the rubber seal on the mason jar during mixing but I remove it during the 30-minute separation periods between mixes to prevent pressure build-up and a possible explosion. Don't worry about emulsions because vibration can help remove them, also I use my glass stirring rod to mix the soup and it does wonders to help separate the layers if they don't do so automatically.
- When you are happy that your solvent has dissolved enough DMT, siphon the solvent layer off into an 8x8 Pyrex dish, put the lid on and let it freeze for 12 hours MINIMUM!
-Don't worry about leaving a thin layer of solvent in the mason jar as it gets difficult to siphon without sucking any base into the pipette. We will add more solvent on top to start what's called the 2nd pull (you can reuse the solvent from the 1st pull once you bring it back to room temp before adding it back into your base). Once you do this just repeat the mixing and siphon process and it's recommended to do this 3 times (3 pulls) overall but you can do it as many times as you want. You can reuse solvent as many times as you want also, so please don't waste it as it is crucial to the process because it is where the DMT molecules are suspended until the freeze precipitation crystallises them.
