Looking for a simple re-x tek

[Lyghtsout]

I got a few drops of lye in my pulls. I've smoked the DMT a few times, it hasn't been harsh, no ill effects, there seems to be nothing wrong with it. It's playing in my mind that I know a few drops of the basic soup got into the mix.

I've been using the search engine like crazy before posting this.

From what I understand, NaOH doesn't evaporate at the temperatures used to smoke DMT. However, it's possible particles of NaOH can get into your lungs. My first question, is my DMT really dangerous? If these particles did get through in a low amount, what would be the ill effect?

I really want to avoid a re-crystallization of the substance. This is mainly because getting the extraction was so difficult for me, and now to recrystallize? I'm afraid I'll mess it up and end up empty handed. If you guys say that what I have is really dangerous, I don't see another option other then to toss it so might as well re-x at that point.

If I really need to re-x what's the simplest tek out there? I've been searching for something simple and straightforward as can be. From what I understand, the DMT is added to a warm solvent at which point the DMT is going to separate from the gunk which should go to the bottom. Wouldn't it be possible to just throw the DMT and Naphtha in a long/small beaker with 25ml/g then dipping it in water pre-warmed to 40-50 degrees Celsius until it separates then use a eye dropper to separate the top layer and putting it on a pyrex dish?

Thank you

 

[Dreamstate1151]

Isn't a shot glass really difficult to scrape out of , especially goo? What about the bottom of the shot glass?

 

[Asher7]

My ocd is going heywire with the thought of putting wood chopsticks into saturated solvent that’s going to absorb into the wood.:shock:

 

[blue.magic]

What I do is to place crude DMT in a small beaker (i.e. shotglass), then pour over it minimum amount of solvent (naphtha, heptane etc.) - just enough to cover the spice and little extra. I place the beaker in a hot water bath and stir the spice. I can add little bit of solvent until all the DMT is visibly gone. What is left on the bottom is usually brown sludge. I carefully decant the supernatant solvent into a Pyrex dish and repeat the procedure with fresh solvent.

I repeat this several times until no DMT precipitates on pouring. You can test this by pouring a drop on a glass and when the solvent evaporates, it should leave little to no residue.

Then I close the Pyrex dish and freeze-crystallize the now purified crystals.

Don't worry about using little more solvent, most will still crystallize out of solution assuming you used naphtha or heptane.

Even evaporating the solvent will yield much purer product since most of the impurities have way lower solubility in the solvent than DMT.

Note the brown residue is still active and can be used as long as the impurities are not harmful.

 

[Crazylegsmagoo]

helpful info!