Lsa extraction method with questions ??

[Michaelt9627]

***Materials needed***
Clean work area
Lsa containing Seeds: untreated organic Morning Glories (heavenly blue)
Polar solvent: Isopropyl alcohol (99%)
Canning Jars(2)
Blender/ coffee grinder:
Pyrex dish
Coffee filters
Funnel
Razor blade
Lemon juice
Peppermint oil


1- take the desired amount of seeds
(I'm using 1000) and blend them in the blender until they are powdered , keep the seeds out of light as much as possible during this process as light destroys lsa, after powdering the seeds place them into a Canning jar

2- take the. 99% Isopropyl alcohol. And pour it. Slightly Over the level of seed powder in the jar , now cap the jar and cover. Any location light could get through with tin foil and place the jar in the freezer for half. An hour

3- after 30 minutes has passed. Go into the freezer and agitate the seed alcohol solution. By shaking it , this is done to ensure of a full extraction . Agitation. Should. Be done every 15 minutes. For. The next 2 hours Equaling 8 sessions of mixing the solution

4- after 2 and a half hours of. Having. Your solution in the freezer Take. Your 2nd canning jar(covered like the first one ) and. Place. The funnel. Into the jar. With a coffee filter in the funnel. To filter The solution and keep the seed mush from falling Through funnel ... Now. Filter the seed mush after the all of the alcohol has Drained in The 2nd jar. Remove the funnel. And take the coffee filter and. Squeeze. It out into. The jar. Making sure not to spill any seed mush into the jar now discard the. Coffee filter with the seed mush

5- now it's time to add a few things to the 2nd jar ,add 2-3 drops of lemon juice , add 10-15 drops of peppermint oil, cap it and shake the jar a few times and place in the freezer for 1-2 hours

6- after 1-2 hours has passed. Take your Pyrex dish And empty the liquid from your jar into the Pyrex dish. Now it's time. To evaporate the the alcohol leaving. The extracted alkaloids behind , place your Pyrex dish in an area were it won't get contaminated of tampered with This location must be cool and dark Becouse heat and light deteriorate lsa

7- After. All of the Alcohol has evaporated. You should be left. With lsa powder or a lsa sticky goop which. Is of 1000 seed potency So. U can divide that into 4 even piles
Which would be equivalent to around 150-250 ug of lsd per pile which is about 1 average. Strength lsd tab Scrape up all of the material. In the Pyrex dish and store it in an air tight container in a cool dark place

Does all of these seem like it would be a valid tek for. Extracting lsa For a potent extraction. With only a slightly nauseating Trip ? I plan on dosing around 500-750 seeds worth I am a 6 foot 200lb male. Does. This seem like an adequate dose ? I'm trying to have a spiritual trip and be out if this world with intense visuals. I've dosed. 3 very high quality tabs of real lsd at once before. For an amazing trip it was very intense but easy going I've tripped on 7 gs of mushrooms and have done plenty of molly and lsd I can't get anymore. Real lsd So I wanna trip off of lsa and not do research chemicals

 

[frobot]

Weleome to the Nexus!
On step 2 there is no reason keep the alcohol cold as far as I know. You could go from freezing to warm back and forth to help break things down, and then make sure it is warm when you filter. It should hold more while it is warm. (make sure it's not actually HOT, just warm or room temp)
There might be a chance that being cold would make the alcohol more selective for the good alkaloids and less selective for the bad stuff. And in an extraction like this without a defat or anything that would be good. But I haven't personally tested that or heard that it is more effective cold.
Maybe someone else can say, but other than that it seems solid to me.
I would start out kinda low and see how your stomach likes it, since this extraction still has potential for nausea. It can depend on the person but the amount you are using (over 500) could be unpleasant.

Also LSA is rarely visual with eyes open. It's more of a head state and colors will be more bright/saturated and music is greatly enhanced.


If you have access to naphtha and toluene/DCM you can really refine it a bit. But if this is your first extraction, this is a wonderful and safe way to get into the groove of things.

 

[sigma&pi]

Please post back about the outcomes of this TEK... I found many posts and some threads on this forum that describe some TEKS, tell about performing some and end up with something like "I'll report back after trying this"... And they rarely report back.

I'm curious about extracting LSA, I know someone who's trying to come up with some effective method but is still unsuccessful :?

I believe the TEK You described would end up with some goo that would be hard to dose and work with. Maybe it would be better to dissolve it in an alcohol solution that would be easier to dose?

 

[frobot]

My uncles friend has done some pretty extensive testing on different methods and had some good results.
I plan on writing up a... not so much tek... but summary of things that worked best for him once I get full membership (Nowhere appropriate is available for me to post this as of now)

Edit: I did not realize that new members could also post in the research section.
I will write this up as soon as I have the time =)