N,N-DMT HCl?

[psychonut]

Does anyone out there "gas" their DMT base with Hydrogen Chloride to form the HCl salts for insufflation or injection?
I hope this topic is not taboo, it just seems that it would be easier to "gas" your solvent after a "pull" and be done with it.
I won't detail the gassing process here, unless asked, just in case it is a touchy subject. I feel sure that enough people out there will know what I am referring to as it is.
Also, Is DMT HCl smokable as are some other HCl salts?
Please let me know.

 

[endlessness]

Regarding IV DMT, please check our FAQ:

FAQ - DMT Frequently Asked Questions and Troubleshooting Guide - DMT-Nexus Wiki

wiki.dmt-nexus.me

As for DMT HCl, it is hygroscopic, wont form a stable salt, rather a goo, so forget about it. DMT fumarate was what was used in strasmann's research, but please check the safety tips on above link if you consider IVing.

As for smokable DMT salts, better use freebase for smoking. Salt forms are often less or completely innefective, or even possibly irritant/toxic (for example smoking DMT fumarate can lead to maleic anhydride, which is def not good to breathe).

 

[psychonut]

Thanx for the info, and no, I wasn't going the IV route.
Very informative and saved me a lot of unnecessary work.
I can't really do a "freezer tek" (precipitating via low temps) where I am, how about just letting my sol evaporate?
Also, in my other life I used odorless Min. spirits to pull. That didn't seem to work very well in this case as it doesn't evaporate for shit.
I have Naptha and Xylol (Xylene/Benzene mix), which way should I go?
Any suggestions?