Hamilton Bardwater
Rising Star
- Merits
- 42
Due to certain circumstances, the freeze precipitation method, I fear, may be out of the question for me.
I'm fully able to perform the rest of the desired tek, though the finialisation will be difficult.
Aside from leaving the naptha in a flat tray with a large surface area under a fan, is there any other way to evaporate it without spoiling my freebase goodies?
I was thinking about heating up an aluminium (disposable) tray to 30-40 degrees in the oven and sitting aproximately 200ml of naptha solution in it. (low depth = faster evaporation?)
Whilst this took place I would heat another tray to the same temperature, and by the time the heat had dissipated from the tray in use, I would pour the solution into the heated one.
To me, this seems like a viable procedure, as I think the 30-40 degree heat (celsius) will be below the crystal's boiling point, so there will be little loss of end product.
I'm fully able to perform the rest of the desired tek, though the finialisation will be difficult.
Aside from leaving the naptha in a flat tray with a large surface area under a fan, is there any other way to evaporate it without spoiling my freebase goodies?
I was thinking about heating up an aluminium (disposable) tray to 30-40 degrees in the oven and sitting aproximately 200ml of naptha solution in it. (low depth = faster evaporation?)
Whilst this took place I would heat another tray to the same temperature, and by the time the heat had dissipated from the tray in use, I would pour the solution into the heated one.
To me, this seems like a viable procedure, as I think the 30-40 degree heat (celsius) will be below the crystal's boiling point, so there will be little loss of end product.
