oversoul1919
Rising Star
OK, this is a new knowledge of Oversoul's so watch carefully. 
You will need:
1 J hook pipe such as Vaponic Cane Gun. They are very cheap, that's the main point behind this all.
2. Metal dish scrubber. Such as Chore Boy.
3. Something with good heat to burn off scrubber residue which factory puts on as protective coating. You want to burn this off because I don't think it is very healthy to inhale. Jet lighter will do work.
So, assembly is really simple. Take the scrubber and cut off one smaller piece which will be used for bottom part of your pipe. This is where your goods are going to be vaporized. Cut the sufficient piece, and burn the protective coating off. Please do this. Think of your health.
So, with the piece of scrubber, put it down stem of your pipe, but don't push it too far, as you will need to remove it for maintenance later. It would be best to make it conical, so that your goods become harder to escape along walls of the pipe. So, try to make your scrubber plug conical. Push it down with pencil or something similar.
With that finished, do the following. Cut one more piece of scrubber. Now this is for the purpose of protecting your goods from open flame, as you know how sensitive it is. Again, burn off the residue!
Now, you will see how it looks like, there are two plugs and DMT is sandwiched between them
Now, this will take some practice. You might not be very successful at first, maybe your DMT is not protected and sandwiched good enough, maybe you're not careful with the flame and such. But when you get a hang of it, boy believe me, nothing but the maybe original GVG will work better.
Peace and love my fellow Nexians.
You will need:
1 J hook pipe such as Vaponic Cane Gun. They are very cheap, that's the main point behind this all.
2. Metal dish scrubber. Such as Chore Boy.
3. Something with good heat to burn off scrubber residue which factory puts on as protective coating. You want to burn this off because I don't think it is very healthy to inhale. Jet lighter will do work.
So, assembly is really simple. Take the scrubber and cut off one smaller piece which will be used for bottom part of your pipe. This is where your goods are going to be vaporized. Cut the sufficient piece, and burn the protective coating off. Please do this. Think of your health.
So, with the piece of scrubber, put it down stem of your pipe, but don't push it too far, as you will need to remove it for maintenance later. It would be best to make it conical, so that your goods become harder to escape along walls of the pipe. So, try to make your scrubber plug conical. Push it down with pencil or something similar.
With that finished, do the following. Cut one more piece of scrubber. Now this is for the purpose of protecting your goods from open flame, as you know how sensitive it is. Again, burn off the residue!
Now, you will see how it looks like, there are two plugs and DMT is sandwiched between them
Now, this will take some practice. You might not be very successful at first, maybe your DMT is not protected and sandwiched good enough, maybe you're not careful with the flame and such. But when you get a hang of it, boy believe me, nothing but the maybe original GVG will work better.
Peace and love my fellow Nexians.
