Separating Plant fat and DMT in NAPHTA using A/B

[Johnbip]

I have some Naphta with DMT and some plant oil in it. Can I do an A/B to extract the DMT from the Naphta?

I am experimenting this at the moment ;

it took the Naphta with DMT and plant oil and added vinegar + distilled water. It became very cloudy. I mix it several times before to let it settle into 2 different layers. I separated the Naphta and acid solution. And I repeated this 2 times. I also added some salt to help break the emulsion.

Then I basified with sodium hydroxide, it became very cloudy/milky I add salt and water to it to break the emulsion.
I then added clean Naphta to get the clean DMT. I mix it, heat it up and mix again. they were some flakes floating in the Alcaline solution. Could it be DMT Freebase?

I separated the Naphta from the Alcaline solution, and repeated 2 more time with fresh Naphta.

I let evaparate the Naphta to reduce 1/2 in size and then place it in the freezer

Is this an effective way to clean DMT of is there too much loose in doing this method.

I also noticed that the acid solution that contained DMT acetate, was white but when I added Naphta to extract DMT, the Naphta became Yellow. Is it the normal color of DMT being yellowish?

what do you think about this, would you do it to purify yours?

I took picture right after i added the lye, it first became very milky and then some stuff started to float.

 

[Johnbip]

Once I added the Naphta to the alkaline solution, it created an emulsion, I also added loads of salt to break it down.
There were a layer of particles in between the 2 layers. Are they impurities or DMT?