Single mesh in Profile PS ?

[Kret]

I have bought Profile PS RDA which is intended to be used with a dual mesh.
I've read somewhere that it is possible to do a single mesh setup with it but can't find it how. Would appreciate if any of the PS users can help me with setting it up.

 

[1Starway7]

All you need is a single mesh for an E Mesh unit...

use .....[vandy vape ss 316l mesh].... in a roll...cut the SS mesh to fit...

Using vandy vape mesh in a roll you might be able to string one mesh across all contacts depending how it made...

Vandy Vape Mesh Wire Spools - 5 Feet

Element Vape
https://www.elementvape.com › vandy-vape-mesh-wire...




Vandy Vape Mesh Wire Spools presents a performance-ready mesh sheets in a plethora of heating elements that caters to mesh rebuildable platforms, featuring KA1 Mesh Wire, Ni80 Mesh Wire, and SS316L Mesh Wire.

 

[Kret]

I've bought vandy vape ss316l 150 mesh with the RDA.

I managed to figure it out. All I had to do was to change parallel pin to series pin which allowed me to connect mesh like so in the picture.

I've tested it last night melting 13mg of spice and then vapourising it at 210*C which took like 3s. I cant believe what I experienced from that dose as before I was using glass pipe with a torch.

 

[1Starway7]

I've bought vandy vape ss316l 150 mesh with the RDA.

I managed to figure it out. All I had to do was to change parallel pin to series pin which allowed me to connect mesh like so in the picture.

I've tested it last night melting 13mg of spice and then vapourising it at 210*C which took like 3s. I cant believe what I experienced from that dose as before I was using glass pipe with a torch.

I've bought vandy vape ss316l 150 mesh with the RDA.

I managed to figure it out. All I had to do was to change parallel pin to series pin which allowed me to connect mesh like so in the picture.

I've tested it last night melting 13mg of spice and then vapourising it at 210*C which took like 3s. I cant believe what I experienced from that dose as before I was using glass pipe with a torch.

you should have bought an RDA that uses ... only one mesh.... with only [two contacts that is level across the top] ...but you can make yours work...

if you take the time you can ...pre shape....or ... .pre bend the mesh to make a small bowl shape ... that will hold 10 to 30 mgs of spice without falling off the mesh..

In photo..you might?.. .... be able to remove that high center bump. from RDA?... alowing you to not to have to raise the mesh so high...

the 316 mesh is a good deal because its cheap ..when you burn out the mesh ..its easy to replce...with 5 ft roll of 316...!

 

[Kret]

I cant remove the centre piece unfortunatelly. I since bended the sides of the mesh to create a dip to hold the spice whilst mslting it and works great.
I also ordered the knock of versions of vandy vape.

 

[Jona]

I've bought vandy vape ss316l 150 mesh with the RDA.

I managed to figure it out. All I had to do was to change parallel pin to series pin which allowed me to connect mesh like so in the picture.

I've tested it last night melting 13mg of spice and then vapourising it at 210*C which took like 3s. I cant believe what I experienced from that dose as before I was using glass pipe with a torch.

That setup looks perfect, just like Minty Love recommends in his site for the Wotofo Profile PS. I'm waiting mine to arrive in a couple of weeks