• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

VandyVape M V2 RDA alternative

Migrated topic.
Sort by date Sort by votes
artificer said:
I've found Wotofo Profile PS at local vape shops. It's a dual mesh, but you can convert it to single mesh with included hardware.

Check this thread out direct e-mesh
Click to expand...

Artificer I finally got my adaptor for the 810-510 so I'm ready to build this thing! Hoping by SS315L mesh is the right kind.

Now I just need to set the Aegis parameters for pulse torching the mesh and then setting them correctly for spice time.
 
Upvote 0 Downvote
CloudyDays said:
I use a Wotofo Profile 1.5 with good results, but I don’t think it is still available.
Click to expand...

What settings do you use for pulsing new mesh and what settings do you use for vaping spice?

I have the Wotofo Profile 1.5 and a Geekvape S100 with 316L Mesh. I finally have all the parts now so looking forward to experimenting.
 
Upvote 0 Downvote
Each persons' settings will be slightly different, depending on resistance of mesh that you cut. My first profile is set to 42 watts to get the screen to glow mildly (enough to burn stuff off) and for the spice it should be soft glow in darkish room - but I use temp control for spice, worked well @ 385°F last time I used it. If you don't use temp control, it would be an art to preheat mesh for few seconds then short pulses to maintain heat without getting too hot.

I suggest to play around a bit with no spice and see what it takes to get that soft glow.
 
Upvote 0 Downvote
There are lots of knockoffs on Aliexpress. I didn't use the genuine ones but the knockoffs seem to be a good quality to me.
I ordered these:

"RunVape Profile RDA Atomizer Mesh Coil 24mm Tank 316SS 810 Dripping Squonk Mod Mesh RDA"
(this one has a bit limited space for regular emesh solution but seems good for use with a solution mentioned in this thread True E mesh convection !. and ceramic health stone .. - Other - Welcome to the DMT-Nexus as the space between the glowing mesh and the mesh which is holding the vape goods is pretty low and the perforated heating mesh recommended in this thread can be used)

Vmiss Mesh Pro RDA Tank 24mm Adjustable 316SS Mesh Coil with Squonk BF Pin Vaporizer Rebuilding Atomizer
(this one is the one I use for emesh)

They both go for 12-13 Euro including postage.
 
Upvote 0 Downvote
Back
Top Bottom