• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

water in field. how to rescure?

Migrated topic.

Gardenic

Rising Star
Joined
Nov 2, 2014
Messages
72
Merits
42
Hello, i just took (very carefully) pyrex from freezer,

First thing I noticed were loose crystals "swimming" in a dish.

after 15 minutes, field still dont want to dry. i decide to scrape all field, now i have wet mass.

I think water could somehow get from the freezer to dish, I left it open for a while by accident.

Can i rescue this somehow?

it is almost end of my mimosa, which is very very difficult to get in my country;/ (cost two monthly salary) I would like to not lose the last milligrams of my dmt:(
 
Gardenic said:
Hello, i just took (very carefully) pyrex from freezer,

First thing I noticed were loose crystals "swimming" in a dish.

after 15 minutes, field still dont want to dry. i decide to scrape all field, now i have wet mass.

I think water could somehow get from the freezer to dish, I left it open for a while by accident.

Can i rescue this somehow?

it is almost end of my mimosa, which is very very difficult to get in my country;/ (cost two monthly salary) I would like to not lose the last milligrams of my dmt:(

Take it out of the freezer, let it all melt. Add 50ml of warm/hot solvent and mix it around. If you can put the whole thing in a mild heat bath then do that. It'll make sure all the DMT that has formed on the layers of the crystallizing dish dissolves back into the solvent.

Decant this into a 100ml beaker or tall thin glass (large shot glass?) so it's easier to work with.

The water will end up at the bottom of the glass, remove it with a pipette or syringe to the best of your abilities. Get it all out, even if it means losing a few ml of naphtha.

Put the solvent back in your (clean) crystallizing dish and evaporate a little bit of the solvent until you see it saturated again.

Seal it up properly, put it back in the freezer and don't touch it for 24 hours! Problem solved :)
 
Wish I had come across this thread earlier when I was having the same problem, great advice and good luck, gardenic!
 
Thanks Tryptallmine, and LSDvibes!
i hope this will work:P


This is how my dmt looks like,
realy realy bad

clen2.jpg


after flushing was a lot of fat..

clen.jpg


it's a very surprising, because it is always little more or little less like this.

clen3.jpg



I will share a pic in 24h, when dmt will freezing after recrystallization:)
 
success:)
i recrystalizing all what i got, but.. from 1g i ave now somethig about 200mg;p

part.jpg
 
Gardenic said:
success:)
i recrystalizing all what i got, but.. from 1g i ave now somethig about 200mg;p

part.jpg
That yield loss seems high but maybe there were a bunch of fats/oils that got into the mix? But great work! Your DMT looks nice and fluffy!
 
i think, after recrystallization, in a glass was something about 5ml of fat.

I recrystalized this "wet part" and some good part (didnt taking picture), good part is something about 3 times more, than after recrys;p but any way, its good, now i have pure pure dmt;p
 
Back
Top Bottom